Abstract:Zinc tin oxide (ZTO) thin films can be deposited by atomic layer deposition (ALD) with adjustable electrical, optical and structural properties. However, the ternary ALD processes usually suffer from low growth rate and difficulty in controlling film thickness and elemental composition, due to the interaction of ZnO and SnO2 processes. In this work, ZTO thin films with different Sn levels are prepared by ALD super cycles using diethylzinc, tetrakis(dimethylamido)tin, and water. It is observed that both the film growth rate and atom composition show nonlinear variation versus [Sn]/([Sn]+[Zn]) cycle ratio. The experimental thickness measured by spectroscopic ellipsometry and X-ray reflectivity are much lower than the expected thickness linearly interpolated from pure ZnO and SnOx films. The [Sn]/([Sn]+[Zn]) atom ratios estimated by X-ray photoelectron spectroscopy have higher values than that expected from the cycle ratios. Hence, to characterize the film growth behavior versus cycle ratio, a numerical method is proposed by simulating the effect of reduced density and reactivity of surface hydroxyls and surface etching reactions. The structure, electrical and optical properties of ZTO with different Sn levels are also examined by X-ray diffraction, atomic force microscope, Hall measurements and ultraviolet–visible–infrared transmittance spectroscopy. The ZTO turns out to be transparent nanocrystalline or amorphous films with smooth surface. With more Sn contents, the film resistivity gets higher (>1 Ω cm) and the optical bandgap rises from 3.47 to 3.83 eV.

Friction mechanism of zinc oxide films prepared by atomic layer deposition

Atomic Layer Deposition of Zinc Oxide Films: Effects of Nanocrystalline Characteristics on Tribological Performance

Influence of Crystal Structure on Friction Coefficient of ZnO Films Prepared by Atomic Layer Deposition

Reducing Friction Force of Si Material by Means of Atomic Layer-Deposited ZnO Films

PREPARATION AND TRIBOLOGICAL PROPERTIES OF TiO2-ZrO2 THIN FILMS

Deposition and Characterization of AZO Thin Films on Flexible Glass Substrates Using DC Magnetron Sputtering Technique

Characterization and Tribological Behavior of Octadecene, Dodecene and Undecenoic Acid Films on Si Substrate

Microstructure and Optical Properties of ZnO Films Deposited by Radio-frequency Reactive Magnetron Sputtering

Reducing adhesion force by means of atomic layer deposition of ZnO films with nanoscale surface roughness.

Mechanical Properties Of Zirconia Thin Films Deposited By Filtered Cathodic Vacuum Arc

Effect of the ZnO buffer layer thickness on AZO film properties

Preparation and Properties of Zinc Oxide Films by Spin-Coating Water Solution Precursor

Lubrication Behavior of n-hexadecane on ZnO Layer at the Nanoscale: A Molecular Dynamic Exploration

Wear and Morphologies of the SiOx Film on Aluminum Substrate

Initial Oxidation and Interfacial Diffusion of Zn on Faceted MgO(111) Films.

Influence of Postdeposition Annealing on Crystallinity of Zinc Oxide Films

Deposition Condition Investigation of High c-axis Preferred Orientation ZnO Films Produced by RF Magnetron Sputtering

Deposition and Characterization of Sputtered ZnO Films

A tri-layer thin film containing graphene oxide to protect zinc substrates from wear

Nonlinear growth of zinc tin oxide thin films prepared by atomic layer deposition

Sputtering Deposited Ternary Zn1−xCdxO Crystal Films on Si(111) Substrates