Abstract:Dynamic analysis is of great importance not only for understanding the natural characteristics and dynamic response of a rotor-bearing system, but also for supplying knowledge of the fault mechanism. The dynamic analysis of a large-scale water-turbine generator set has rarely been investigated. This article establishes a model of a large water-turbine generator set and presents some research results. This article provides a detailed calculation of the critical speed and vibration modes by the Riccati transfer matrix method (RTMM) to study the influence of stiffness of the guide bearings on the characteristics of the shaft. A detailed dynamic model is presented of the No. I unit of the Guangzhou Pumped Storage Power Station (GPSPS) in southern China, including nonlinear characteristics of the guide bearing, the thrust bearing, and the magnetic force. An efficient simulation method, referred to as the transient Riccati transfer matrix method (TRTMM), is used to calculate the transient response of the rotor-bearing shaft system. Sonic simulation results are also presented for responses to other types of forces such as unbalance inertial forces and nonlinear magnetic forces. Results show that, for large vertical water-turbine generator sets, there exists a common characteristic in the first three vibration modes, that is, the maximum amplitude is at the generator rotor in the first vibration mode, while in the third vibration mode, the maximum amplitude is near the turbine runner. Simulation results show that the method and program are correct and can be used expediently. The response of the rotor-bearing system with different values of preload coefficients of the tilting-pad journal bearing reflects the influence of the bearing clearance on the vibration amplitude and the time required for the vibration from transient state to steady state. The effect of hydraulic forces acting on the runner shows that the vibration amplitude and the time required for the vibration at the three guide bearings to reach steady state are different. The analysis of the lateral shaft vibration caused by nonlinear magnetic forces shows that it will produce a new frequency component of 150 Hz.

MODELING AND CALCULATION OF THE NATURAL FREQUENCY OF 300 MW URBO-GENERATOR ROTOR SHAFT SYSTEM

Analysis of Flexural and Torsional Vibration for Turbogenerator Shafts on Power Impact

Torsional Vibration of a Shafting System under Electrical Disturbances

Modeling a Two-Span Rotor System Based on the Hamilton Principle and Rotor Dynamic Behavior Analysis

Dynamic characteristics of the rotor system for large pump-turbine sets

Coupled Bending and Torsional Vibrations of Geared Rotor System

Research on Transmission Characteristics and Torsional Vibration Control of Hybrid Transmission Wind Turbines

DYNAMIC ANALYSIS OF A HYDRAULIC TURBINE UNIT*

MODEL ANALYSIS AND TEST RESEARCH OF HORIZONTAL-AXIAL MARINE CURRENT TURBINE

Analysis of Shafting System Vibration Characteristics for Mixed-Flow Hydropower Units Considering Sand Wear on Turbine Blades

Natural Frequency and Dynamic Response of Rotor System of Steam Turbine Modelled with Euler-Bernoulli Beam

Torsional Vibration Analysis and Stress Calculation for the Fault 600MW Steam Turbine Generator Shaft System

Numerical Research on Dynamic Lateral Vibration of a Pump Turbine’s Shaft System

Nonlinear Vibration Analysis of the Coupled Gear-Rotor-Bearing Transmission System for a New Energy Vehicle

Rotor-dynamic Characteristics Analysis of a Large-Scale Francis Turbine Shaft-System

Coupled Torsional Vibration and Fatigue Damage of Turbine Generator Due to Grid Disturbance

Torsional and lateral vibration analysis of wind turbine generator bearing outer ring fault considering unbalanced magnetic pull

Investigation of simulation experiment on active control of torsional vibration in a turbogenerator shaft system

Natural Frequency Analysis of Wind Turbines Based on Flexible Multi-body Dynamics

A Unified Modeling Approach for Rotating Flexible Shaft-Disk Systems with General Boundary and Coupling Conditions

Modeling Shaft Damping of Turbine-Generator in Electromagnetic Transient Simulation