Abstract:Dynamic analysis is of great importance not only for understanding the natural characteristics and dynamic response of a rotor-bearing system, but also for supplying knowledge of the fault mechanism. The dynamic analysis of a large-scale water-turbine generator set has rarely been investigated. This article establishes a model of a large water-turbine generator set and presents some research results. This article provides a detailed calculation of the critical speed and vibration modes by the Riccati transfer matrix method (RTMM) to study the influence of stiffness of the guide bearings on the characteristics of the shaft. A detailed dynamic model is presented of the No. I unit of the Guangzhou Pumped Storage Power Station (GPSPS) in southern China, including nonlinear characteristics of the guide bearing, the thrust bearing, and the magnetic force. An efficient simulation method, referred to as the transient Riccati transfer matrix method (TRTMM), is used to calculate the transient response of the rotor-bearing shaft system. Sonic simulation results are also presented for responses to other types of forces such as unbalance inertial forces and nonlinear magnetic forces. Results show that, for large vertical water-turbine generator sets, there exists a common characteristic in the first three vibration modes, that is, the maximum amplitude is at the generator rotor in the first vibration mode, while in the third vibration mode, the maximum amplitude is near the turbine runner. Simulation results show that the method and program are correct and can be used expediently. The response of the rotor-bearing system with different values of preload coefficients of the tilting-pad journal bearing reflects the influence of the bearing clearance on the vibration amplitude and the time required for the vibration from transient state to steady state. The effect of hydraulic forces acting on the runner shows that the vibration amplitude and the time required for the vibration at the three guide bearings to reach steady state are different. The analysis of the lateral shaft vibration caused by nonlinear magnetic forces shows that it will produce a new frequency component of 150 Hz.

Dynamic characteristics of the rotor system for large pump-turbine sets

DYNAMIC ANALYSIS OF A HYDRAULIC TURBINE UNIT*

Modal Characteristics Analysis of a Variable-Speed Pump-Turbine Rotor System: a Perspective of Resonance

Rotor-dynamic Characteristics Analysis of a Large-Scale Francis Turbine Shaft-System

Rotor dynamics analysis on high-power high-pressure multi-stage centrifugal pump

Dynamic Characteristic Analysis of a Pump-Turbine Unit under the High Pressure Pulsation Operating Condition - Fluid Dynamics Analysis

Distribution Features of Flow Patterns and Pressure Pulsations of Pump-Turbine in Five Operating Modes on the Four-Quadrant Plane

Analysis on Modeling Rotor System with Sidling Bearing and Ring Seal by Using FEM

Dynamic characteristic analysis of pressure pulsations of a pump turbine in turbine mode utilizing variational mode decomposition combined with Hilbert transform

Vibration of Variable Speed Pump-Turbine in Turbine Operating Range: Simulation by CFD+FEM

Numerical Theory and Method on the Modal Behavior of a Pump-Turbine Rotor System Considering Gyro-Effect and Added Mass Effect

Numerical Study on the Flow and Structural Characteristics of a Large High Head Prototype Pump-Turbine under Different Operating Conditions

Research of bending-torsional vibrations and bifurcation characteristic of turbopumps rotor

Modelling and Critical Speed Calculation of Large-scale Canned Motor Pump Rotor System

Effect of Unbalanced Magnetic Pull of Generator Rotor on the Dynamic Characteristics of a Pump—Turbine Rotor System

Nonlinear Vibration Analysis of a Low-Pressure Rotor-Bearing System for 200MW Steam Turbine

Experimental and Numerical Investigation of Rotor–Stator Interaction in a Large Prototype Pump–Turbine in Turbine Mode

Dynamic Analysis of a Planar Multi-Stage Centrifugal Pump Rotor System Based on a Novel Coupled Model

Dynamic Analysis and Modeling of Large-scale Canned Motor Pump Rotor Based on ANSYS

Investigate the full characteristic of a centrifugal pump-as-turbine (PAT) in turbine and reverse pump modes

Analysis of Rotor-Stator Interaction in Turbine Mode of A Pump-Turbine Model