Abstract:BACKGROUND: Cavitation is a phenomenon that occurs in vane hydraulic machines: pumps, hydraulic turbines, when the pressure in a certain area of the flow reaches the level of saturated steam pressure. Its occurrence depends on the design and mode of operation of the hydraulic turbine. In order to design a hydraulic turbine with high cavitation qualities, it is necessary to be able to reliably predict this phenomenon. AIMS: The article describes approaches to modeling the operation of Francis hydraulic turbines based on the ANSYS software package. METHODS: Using quasi-3D methods was modeled turbine blade system with 75 meters head. Hydrodynamic computation carried out in single-phase and two-phase formulations using the ANSYS CFX package. RESULTS: The design of a flow path Francis turbine 3D solid model with a specific speed coefficient ns =283 has been completed. The flow part of the hydraulic turbine includes a spiral case, a stator, a guide vane, an impeller and a draft tube. Computational modeling of the flow of a single-phase viscous fluid in a hydraulic turbine in different modes was carried out to construct a universal characteristic. The optimal efficiency is found and the flow characteristics are calculated. The losses in the elements of the flow part of the hydroturbine under various operating modes are determined, the zone of optimal operation is found. The cavitation flow is calculated using a two-phase flow model (water-steam). For both sides of the impeller blade, a pressure distribution was obtained, which can be used to judge the possibility of cavitation in areas where the pressure of the water column is less than the vaporization pressure. The value of the critical cavitation coefficient for the three most unfavorable modes was determined, and the dependence of the efficiency on the cavitation coefficient was constructed. The area occupied by steam on the blade during cavitation flow is visualized, its area is determined relative to the surface area of the blade. CONCLUSIONS: The designed hydraulic turbine has good energy and cavitation qualities, confirmed by the calculation. This version of the hydroturbine can be used as the initial one with further optimization of the blade system and elements of the flow path, to improve the energy and cavitation qualities.

Rotor-dynamic Characteristics Analysis of a Large-Scale Francis Turbine Shaft-System

Dynamic characteristics of the rotor system for large pump-turbine sets

DYNAMIC ANALYSIS OF A HYDRAULIC TURBINE UNIT*

Research on the Hydraulic Characteristics of 1000 MW Francis Runner: Influence of Radial Installation Deviations

Study of the Phase Resonance Phenomenon in Francis Turbine

Study on Safety Operation for Large Hydroelectric Generator Unit

Strength and Vibration Analysis of a Francis Turbine

Transient Flow Dynamics Analysis of a Large Prototype Francis Turbine at Different Loads

Investigating the Performance of a Super High-head Francis Turbine under Variable Discharge Conditions Using Numerical and Experimental Approach

Effects of Head and Discharge on Internal Flow Characteristics of a High-Quality Installed 1 GW Francis Turbine

Analytical Implementation and Prediction of Hydraulic Characteristics for a Francis Turbine Runner Operated at BEP

Vorticity Dynamics Analysis On Flow In Francis Hydraulic Turbine

Testing and Numerical Analysis of Abnormal Pressure Pulsations in Francis Turbines

Analysis on Modeling Rotor System with Sidling Bearing and Ring Seal by Using FEM

Prediction of energy and cavitation characteristics of high specific speed Francis hydraulic turbines

Numerical Study on the Flow and Structural Characteristics of a Large High Head Prototype Pump-Turbine under Different Operating Conditions

Analysis of the Internal Flow Behavior on S-shaped Region of a Francis Pump Turbine on Turbine Mode

Analysis of Shafting System Vibration Characteristics for Mixed-Flow Hydropower Units Considering Sand Wear on Turbine Blades

Comprehensive Hydraulic Improvement and Parametric Analysis of a Francis Turbine Runner

Numerical Analysis of Unsteady Flow under High‐head Operating Conditions in Francis Turbine

Investigation of Pressure Fluctuation and Pulsating Hydraulic Axial Thrust in Francis Turbines