Abstract:In the biomedical micro-electromechanical systems (MEMS) field, the fabrication of three-dimensional (3D) magnetic hydrogel microdevices and microactuators with sizes smaller than 100 mu m is difficult. In this paper, magnetic-field-driven 3D hydrogel microstructures were fabricated through four steps: the synthesis of surface-modified Fe3O4 nanoparticles (Fe3O4 NPs), the preparation of a magnetic gel photoresist, two-photon polymerization microfabrication, and a solvent-exchange process. For the preparation of a stable magnetic gel photoresist, surface-modified Fe3O4 NPs with an average size of 7.8 nm were synthetized and well dispersed in gel photoresist. The magnetic gel photoresist exhibited a good UV photopolymerization effect, and a magnetic-field-driven macroscopic hydrogel was prepared. The two-photon polymerization properties of gel photoresists with various Fe3O4 NP contents were investigated in detail, and the minimum width of fabricated lines reached 106 nm for the photoresist with 0.32 wt% Fe3O4 NPs. Three hydrogel microstructures-the Qingdao University logo, a magnetically actuated micro-rod, and a magnetically actuated micro-nail-were successfully fabricated using a gel photoresist with 0.96 wt% Fe3O4 NPs. Importantly, obvious and reversible external-magnetic-field-driven bending behavior of the 3D hydrogel micro-nail with a size of 10 mu m was observed.

Fabrication of three-dimensional micro-Rogowski coil based on femtosecond laser micromachining

Fabrication Of 3d Solenoid Microcoils In Silica Glass By Femtosecond Laser Wet Etch And Microsolidics

Facile Fabrication of True Three-Dimensional Microcoils Inside Fused Silica by A Femtosecond Laser

Process for the fabrication of complex three-dimensional microcoils in fused silica.

Fabrication of high-Q microresonators in dielectric materials using a femtosecond laser: Principle and applications

Femtosecond Laser Direct Writing of High-Q Microresonators in Glass and Crystals

Fabrication of Optical Cavities with Femtosecond Laser Pulses

Three Dimensional Multilayer Solenoid Microcoils Inside Silica Glass

High-level Integration of Three-Dimensional Microcoils Array in Fused Silica

Fabrication of 3D electro-thermal micro actuators in silica glass by femtosecond laser wet etch and microsolidics

Resonant Micro Optic Gyro Using Tens of Centimeters Long Optical Fiber Coil

A Miniaturized Rogowski Current Transducer with Wide Bandwidth and Fast Response

Design and Fabrication of Micro RF Coil for MRI

Three-dimensional Metallic Microcomponents Achieved in Fused Silica by a Femtosecond-Laser-based Microsolidifying Process

3D Microtransformers with Air Core Inside Fused Silica

Wafer-Level Fabrication Process for Micro Hemispherical Resonators

Manufacture of 3-D Microfiber Coil Resonators

Magnetic-field-driven Ultra-Small 3D Hydrogel Microstructures: Preparation of Gel Photoresist and Two-Photon Polymerization Microfabrication

Fabrication of Electromagnetically-Driven Tilted Microcoil on Polyimide Capillary Surface for Potential Single-Fiber Endoscope Scanner Application.

Optimized Design of Microcoil Resonators

Fabrication of Three-Dimensional Metallic Microcomponents in Fused Silica by a Femtosecond Laser & Micromoulding (FLM) Method