Abstract:Cu/Al composites have the excellent properties of both Cu and Al, and have the properties of light weight and high conductivity, so they have been widely concerned. In this paper, 5-mm-thick Cu/Al composites prepared by the cast-rolling process are used as experimental materials. To reveal the strengthening and toughening mechanisms of the Cu/Al composites, the interfacial structure, micro-morphology, stress-strain condition, and GND distribution of Cu/Al composites before and after deformation were characterized utilizing TEM, TKD, and EBSD. The results show that the submicron intermetallic compounds Al 2 Cu and Al 4 Cu 9 are formed from the casting-rolling Cu/Al composites. After 15% tensile deformation, many gaps occurred in the interface layer, but at the gaps, there was no crack spreading to the Cu and Al layers. Meanwhile, the deformation in different directions occurs in the Cu grains near the interface, forming a dislocation wall, and the entanglement of the dislocation occurs in the Cu layer near the interface, which contributes to the improvement of tensile strength. The Al layer near the interface layer produces kink bands, which helps to improve the ductility of the composites. Besides, due to the action of the hard intermetallic compound layer, with the increase in tensile deformation, a large number of GND are gradually accumulated in the Cu and Al layers near the interface, resulting in remote back stress, which makes the softer Cu and Al layers obtain higher strength. At the same time, the back stress caused by GND will induce strain hardening, which helps to maintain ductility, so that Cu/Al composites have higher plastic deformation ability while improving mechanical properties.

Evolution of FCC/BCC interface and its effect on the strengthening of severe drawn Cu–3wt.% Cr

EFFECT OF HEAVILY DRAWING ON THE MICROSTRUCTURE AND PROPERTIES OF Cu-Cr ALLOYS

Study on interface behavior of Be/CuCrZr alloy by diffusion bonding

Microstructure and Properties of Cold Drawing Cu-2.5% Fe-0.2% Cr and Cu-6% Fe Alloys

Dislocation assisted face-centered-cubic/body-centered-cubic interface mixing during severe plastic deformation

Strain Compatibility Behavior in Cu-6%Ag Alloy During Drawing into Filamentary Structure

Microstructure Evolution of Cu/Ag Interface in the Cu–6 Wt.% Ag Filamentary Nanocomposite

Effects of Cr addition on the microstructural, mechanical and electrical characteristics of Cu–6wt.%Ag microcomposite

Microstructure evolution and properties of Cu–Ag microcomposites with different Ag content

Deformation of Fe and Ag Precipitates in Cu Matrix

Evolution of Microstructure and Fe/Fe3C Interface Structure in Cold‐Drawn Pearlitic Steel Wires

Study on strengthening and toughening mechanisms of cu/Al composites dominated by interface layer

Segregation mechanism of alloying elements at the fcc-Fe/bcc-Fe interface and its effects on carbon diffusion across the boundary

Evolutions of the microstructure and electrical conductivity of Cu-6wt%Ag alloy during drawing strain

Crack-resistant σ/FCC interfaces in the Fe40Mn40Co10Cr10 high entropy alloy with the dispersed σ-phase

On the Evolution of Nano-Structures at the Al–Cu Interface and the Influence of Annealing Temperature on the Interfacial Strength

Interface evolution and strengthening of two-step roll bonded cu/Al clad composites

Effect of drawing deformation on microstructure and mechanical properties of Fe-Cr-Co-W alloy

Effects of Ce additions on microstructure and properties of Cu-15Cr in situ composite

A Possibility to Synchronously Improve the High-Temperature Strength and Ductility in Face-Centered Cubic Metals Through Grain Boundary Engineering

Characterization of the interfacial micro-zones in C18150Cu/8011Al laminated composites