Abstract:Cation substitution is a promising approach to reduce the antisite defects and further improve the efficiency of Cu2ZnSn(S,Se)4 (CZTSSe) cells. In this paper, silver (Ag) has been introduced into Cu2ZnSn(S,Se)4 (CZTSSe) thin film to replace Cu partially and form (Cu1-xAgx)2ZnSn(S,Se)4 (0 ≤ x ≤ 1) (CAZTSSe) alloy films by combination of solution method and a rapid annealing technique. The fundamental properties of the mixed Ag-Cu kesterite compound are systematically reported as a function of the Ag/(Ag+Cu) ratio. The results show that band gap of kesterite CAZTSSe is incessantly increased by adjusting the Ag doping content, indicating that the CAZTSSe alloy film is a potentially applicable bandgap grading absorption layers material to obtain higher CZTSSe device. Furthermore, CAZTSSe alloy films with better electrical performance were also obtained by adjusting the Ag content during film fabrication. Finally, we also observed an increment in open circuit voltage (Voc) by 160 mV and an accompanying rise in device efficiency from 4.24 to 5.95%. The improvement is correlated to the improved grain size and decreased antisite defects of Cu instead of Zn site (CuZn) in the lattice. The Voc enhancement evidences that the solution method is facile and viable to achieve proper cation substitution toward higher efficiency kesterite solar cells. In addition, the CAZTSSe cell also displays better charge collection performance because of the higher fill factor (FF) and power conversion efficiency (PCE). Therefore, it can be concluded that the doping of Ag is a potentially appropriate method to reduce the Cuzn antisite defects of CZTSSe and improve efficiency of CZTSSe device.

The role of Ag in (Ag,Cu) 2 ZnSnS 4 thin film for solar cell application

Formation of Alloyed Cu2CoxZn1-xSn(S,Se)4 Absorption Layer and Its Application in Solar Cells.

Formation of Alloyed Cu2Cox Zn1-x Sn(S,Se)4 Absorption Layer and Its Application in Solar Cells

Zn As the Protective Layer for Cu Electrode in Wafer-Si Solar Cells

Formation of Alloyed Cu 2 Co x Zn 1- x Sn(S,Se) 4 Absorption Layer and Its Application in Solar Cells

Low-cost Fabrication of Cu 2 ZnSnS 4 Thin Films for Solar Cell Absorber Layers

Thin film solar cells based on Ag-substituted CuSbS2 absorber

Improved Cu2ZnSnS4 Solar Cell Performance by Multimetallic Stacked Nanolayers

Synthesis and characterization of CZTS and Cu2-xAgxZnSnS4 thin films for the application of solar cells

Substitution of Ag for Cu in Cu2ZnSn(S,Se)4: Toward Wide Band Gap Absorbers with Low Antisite Defects for Thin Film Solar Cells

Synergistic Effect of Ag, Sb Dual‐Cation Substitution on Cu2ZnSn (S, Se)4 High‐Efficiency Solar Cells

Colloidal synthesis of zincblende Cu3InSnS5 nanocrystals and their application in the thin-film solar cell

Synthesis and Characterization of Hydrazine Solution Processed Cu12Sb4S13 Film

Efficient kesterite Ag-alloyed Cu 2 ZnSn(S,Se) 4 thin film solar cells with a front Ag grading distribution enabled by ZnO insert layer

Chemical synthesis of Cu(In) metal inks to prepare CuInS2 thin films and solar cells

Se as hetero-nucleation seeds reinforcing intermetallic diffusion for improved electrodeposition-processed CZTS solar cells

Preparation and Characterization of Cuins2 Thin Films for Solar Cells by Chemical Bath Deposition

Analyzing the synergistic effect of Ag and Ge co-incorporation on Cu2ZnSnSe4 thin-film solar cells

Preparation And Characterization Of Cu2znsns4 Thin Films And Solar Cells Fabricated From Quaternary Cu-Zn-Sn-S Target

Reducing carrier recombination loss by suppressing Sn loss and defect formation via Ag doping in Cu2ZnSn(S,Se)4 solar cells Reducing carrier recombination loss by doping Ag in Cu2ZnSn(S,Se)4 solar cells

Enhancing Ag-alloyed Cu 2 ZnSnS 4 solar cell performance by interfacial modification via In and Al