Abstract:Cu2ZnSn(S,Se)4 (CZTSSe) is a hopeful substitution to commercialized Cu(In,Ga)Se2 (CIGSe) devices with similar structure and optoelectronic properties and has advantages of nontoxicity, low cost, and abundant reserves. However, the traditional flat bandgap structure of the CZTSSe absorber layer does not efficiently enhance the collection of photogenerated electrons and decrease recombination. Graded bandgap engineering toward the interfaces of CIGSe solar cells is the key to realize high-efficiency devices. In this study, we obtained (Cu1-xAgx)2ZnSn(S,Se)4 (CAZTSSe) absorber layers with high-concentration Ag doping at both ends of the absorption layer and undoped or low-concentration Ag doping in the middle part through a new miscible layered precursor method. This bandgap structure suppressed CuZn defects, delayed Fermi level pinning near the CZTSSe/CdS interface, sustained good electrical conductivity and light absorption in the middle of the absorption layer, improved the conversion efficiency of incident light, and inhibited recombination of carriers toward the Mo back electrode. In addition, we also compared the performance of undoped, uniformly Ag-doped, and V-type Ag-doped CZTSSe devices to acquire a deeper understanding of the reasons for the enhanced performance. It can be found that compared with undoping, the open-circuit voltage (Voc) of the best devices with uniform doping (x = 15%) increased from 379 to 386 mV, the fill factor (FF) increased from 44.70 to 54.14%, and the photoelectric conversion efficiency (PCE) increased from 4.63 to 6.21%. More surprisingly, the Voc of the optimal CAZTSSe devices (sample D) with Ag-graded doping was increased to 413 mV and the FF was increased to 59.63%. It also achieved an impressive PCE of 7.35%. The above results prove the importance of tuning Ag gradient doping of CZTSSe films for improving solar cell performance.

Analyzing the synergistic effect of Ag and Ge co-incorporation on Cu2ZnSnSe4 thin-film solar cells

Formation of Alloyed Cu2Cox Zn1-x Sn(S,Se)4 Absorption Layer and Its Application in Solar Cells

Formation of Alloyed Cu2CoxZn1-xSn(S,Se)4 Absorption Layer and Its Application in Solar Cells.

Synergistic Effect of Ag, Sb Dual‐Cation Substitution on Cu2ZnSn (S, Se)4 High‐Efficiency Solar Cells

Substitution of Ag for Cu in Cu2ZnSn(S,Se)4: Toward Wide Band Gap Absorbers with Low Antisite Defects for Thin Film Solar Cells

Impact of Cation Substitution in (Ag x Cu 1− x ) 2 ZnSnSe 4 Absorber‐Based Solar Cells toward 10% Efficiency: Experimental and Theoretical Analyses

Improving the performance of low-cost water-based solution-synthesised Cu2ZnSn1-Ge (S,Se)4 absorber thin films by germanium doping

Enhancing Open-Circuit Voltage of Solution-Processed Cu 2 ZnSn(S,Se) 4 Solar Cells with Ag Substitution

Improving the performance of kesterite solar cells by solution germanium alloying

Surprising Efficiency Enhancement of Cu 2 ZnSn(S,Se) 4 Solar Cells with Abnormal Zn/Sn Ratios

Surprising Efficiency Enhancement of Cu2ZnSn(S,Se)4 Solar Cells with Abnormal Zn/Sn Ratios

Energy Band Alignment and Defect Synergistic Regulation Enable Air-Solution-Processed Kesterite Solar Cells with the Lowest VOC Deficit.

Realization of Grain Growth and Suppressed Bulk Defects for Efficient Solution-Processed Cu2ZnSn (S, Se)4 Solar Cells Via Co-Doping Strategy

Optimizing the properties of Cu2ZnSn(S,Se)4 solar cells via cationic substitution with trace Ca

Enhancement of power conversion efficiency of Ag-substituted Cu2ZnSn(S,Se)4 solar cells via tuning Cu2+/(Cu++Cu2+) percentage in precursor solution

Passivating SnZn Defect and Optimizing Energy Level Alignment via Organic Silicon Salt Incorporation toward Efficient Solution‐Processed CZTSSe Solar Cells

Insights into the Efficiency Improvement for CZTSSe Solar Cells with over 12% Efficiency Via Ga Incorporation

Further Boosting Solar Cell Performance Via Bandgap-Graded Ag Doping in Cu2ZnSn(S,Se)4 Solar Cells Compared to Uniform Ag Doping

Achieving 11.23 % Efficiency in CZTSSe Solar Cells Via Defect Control and Interface Contact Optimization

Growth of Cu2znsnse4 Film under Controllable Se Vapor Composition and Impact of Low Cu Content on Solar Cell Efficiency

Passivation of Deep‐Level Defects through Chemical Environment Regulation for Efficient CZTSSe Solar Cells Based on Active Selenium Adsorption–Desorption Process