Abstract:Quaternary semiconductor Cu2ZnSnSe4 (CZTSe) is a very promising alternative to semiconductors based on indium (In) and gallium (Ga) as solar absorber material due to its direct band gap, inherent high absorption coefficient (>104 cm−1) and abundance of cheap elements zinc (Zn) and tin (Sn). In this study, high quality CZTSe thin films were successfully synthesized by a green and low-cost solution based non-vacuum method, which involves spin coating non-toxic solvent-based CZTSe nano-inks onto Mo coated soda lime glass substrates followed by selenization with elemental Se vapor. The effect of selenization temperature on structural, morphological, compositional and optical properties of CZTSe films are investigated using X-ray diffraction (XRD), Raman spectroscopy, scanning electron microscopy (SEM), energy dispersive spectroscopy (EDS) and photoluminescence spectroscopy. XRD and Raman analysis indicates that a tetragonal stannite-type structured CZTSe is formed. Depend on the selenization temperature, the dense and compact films with grain sizes from 200 nm (500 °C) up to about 1 μm (580 °C) are obtained. EDS measurement indicates that the composition ratios of the prepared CZTSe films are copper-poor and zinc-rich nature. The CZTSe films are p-type conductivity confirmed by a hot point probe method. Photoluminescence spectrum shows slightly asymmetric narrow bands with a maximum of intensity at 0.92 eV. The dependence of the photoluminescence on the excitation temperature reveals a decrease in the intensity of the photoluminescence bands. An absorption coefficient exceeding 104 cm−1 and the band gap energy about 0.87 eV of the studied films are determined by an absorption spectroscopy.

Compression for Smoothing and Densifying CuInSe2 and Cu2ZnSnSe4 Thin Films Coating from Oxides Nanoparticles Precursor

Effect of Compact Structure on the Phase Transition in the Oxides Derived Cu2ZnSnSe4 Thin Films

Research progress on synthesis of CuIn1-x Gax Se2 nanoparticles

EFFECT OF ANNEALING ON THE CuInS2 THIN FILMS PREPARED BY CHEMICAL BATH DEPOSITION

Research progress on synthesis of CuIn 1-xGa xSe 2 nanoparticles

Nanoparticle Based Preparation Method of Cu_2ZnSn(SSe)_4 Thin Films

Structural and Optical Properties of the Cu2znsnse4 Thin Films Grown by Nano-Ink Coating and Selenization

Selenization of mixed metal oxides for dense and ZnSe-free Cu2ZnSnSe4 absorber films

The Preparation of Cu2ZnSnSe4 Films by Selenization of the Oxide Precursors

Study on the Optimization of Cu-Zn-Sn-O to Prepare Cu2ZnSnS4 Thin Film via a Nano Ink Coating Method

Preparation and characterization of Cu2ZnSnSe4 thin films by selenization of electrodeposited metal precursors

Fabrication of Cu 2 ZnSnS 4 thin films using oxides nanoparticles ink for solar cell

The Formation Mechanism of Cu(In0.7Ga0.3)Se-2 Nanoparticles and the Densification Trajectory of the Se-Rich Quaternary Target by Hot Pressing

Selenization Temperature and Properties of CuInSe2 Films

P-type CuInSe 2 Thin Films Prepared by Selenization of One-Step Electrodeposited Precursors

Solvent-free synthesis of oxides for CuInSe 2 thin films fabrication

Carbon Impurity Minimization of Solution-Processed, Thin-Film Photovoltaics via Ligand Engineering of CuInS 2 Nanoparticles

Inhibiting Aluminum Oxidation in CuInAl Precursor Films: Significance for Achieving High-Performance Cu(InAl)Se2 Solar Cells

Influence Of Annealing Conditions On The Structure And Compositions Of Electrodeposited Cuinse2 Films

A Low-Cost Processing of CuIn(SexSi1-x)2 Films: Using Sulfides Nanoparticle Precursors

Synthesis and Characteristics of Cu(In,Ga)Se2 Thin Films from Nanoparticles by Solvothermal Method and Selenisation Process