Abstract:As tellurides and selenides of Bismuth are extensively used thermoelectric materials in the low-temperature range with refrigeration application, A concerted effort is put forth to boost the ZT by co-doping the pristine Bi 2 Se 3 with antimony (Sb) on cation end and tellurium (Te) on anion side of the compound. The double sintered solid-state reaction method is employed in the preparation of Bi 2 Se 3 and (Bi 1− x Sb x ) 2 Se 2.7 Te 0.3 polycrystalline pellets, with x = 0.02, 0.04, and 0.06. The sample exhibits a rhombohedral structure with the space group of R m. FESEM and EDAX analysis are used to confirm surface morphology and elemental composition of the produced samples. The thermoelectric measurements for the pristine and co-doped samples were conducted by the physical property measurement system as well as a considerable increase in the Seebeck coefficient of − 115 μV/K is observed for 0.02 doping of the Sb which is 4.2 times greater than as for pristine (S = − 28 μV/K). Higher concentration doping ( x = 0.04, 0.06) has not reflected any Seebeck coefficient advancement. In contrast, the lowest total thermal conductivity at a low-temperature regime (< 50 K) is observed for x = 0.06 doping concentration which at near room temperature increases beyond the pristine thermal conductivity; whereas, x = 0.02, 0.04 doping concentration shows a decrement in total thermal conductivity at low, at room temperature region the values are almost equivalent to that of pristine. The co-doped samples' electrical resistivity is substantially less than pristine sample. The highest power factor of 3 × 10 –4 μW/mK 2 is obtained for the x = 0.02 sample. The highest ZT value for the x = 0.02 sample is almost 28 times more than a pristine sample. We conducted a study where we combined experimental and DFT methods to investigate thermoelectric properties incorporated into pristine and doped with antimony and tellurium on Bi 2 Se 3 . We have employed this combination to investigate the partial density of states, Seebeck coefficient, power factor using the Boltzmann transport equation. Theoretical thermoelectric data were derived and compared to experimental observations. Hence, using combined experimental and theoretical investigations helps to predict with higher accuracy of thermoelectric properties of semiconducting materials.

Thermoelectric properties of Bi 2 Se x Te 3−x prepared by Bridgman method

Improved Thermoelectric Properties of Bi2Te3−xSexalloys by Melt Spinning and Resistance Pressing Sintering

Preparation and thermoelectric properties of Bi2Te3-Bi2Se3 solid solutions

Enhanced Thermoelectric Performance of Te-Doped Bi2Se3−xTex Bulks by Self-Propagating High-Temperature Synthesis

Tuning of thermoelectric properties with changing Se content in Sb2Te3

Low Temperature Thermoelectric Properties of Bi2−xSbxTeSe2 Crystals Near the N–p Crossover

Crystal structure and thermoelectric properties of bulk polycrystalline (SbxBi1-x)2Se3 alloys

Electronic and thermoelectric properties of semiconducting Bi2SSe2 and Bi2S2Se monolayers with high optical absorption.

Anisotropic Thermoelectric Properties of N-Type Te-Free (bi, Sb)2Se3 with Orthorhombic Structure

Thermoelectric Properties of Bi2O2Se Single Crystals

Bi8Se7: Delocalized Interlayer π-Bond Interactions Enhancing Carrier Mobility and Thermoelectric Performance near Room Temperature

Optimizing thermoelectric properties of BiSe through Cu additive enhanced effective mass and phonon scattering

Effects of SnSe Addition on the Thermoelectric Properties of Bi0.85Sb0.15Se

A comprehensive experimental and DFT analysis on thermoelectric properties of Sb, Te co-doped Bi2Se3 polycrystals

Isovalent co-alloying contributes to considerable improvement in thermoelectric performance of BiSe bulks with weak anisotropy

Enhanced Thermoelectric Performance of Bi–Se Co-Doped Cu 1.8 S via Carrier Concentration Regulation and Multiscale Phonon Scattering

Expand band gap and suppress bipolar excitation to optimize thermoelectric performance of Bi0.35Sb1.65Te3 sintered materials

Crystal growth and thermoelectric properties of Sn-doped Bi2Se3

Enhanced Thermoelectric Properties of Bi2O2Se by Bi2Te2.7Se0.3 Addition

Electronic structure and thermoelectric properties of PbTe1−xSex from first-principles calculations

Enhanced Thermoelectric Performance of Bi2Se3/TiO2composite