Abstract:As tellurides and selenides of Bismuth are extensively used thermoelectric materials in the low-temperature range with refrigeration application, A concerted effort is put forth to boost the ZT by co-doping the pristine Bi 2 Se 3 with antimony (Sb) on cation end and tellurium (Te) on anion side of the compound. The double sintered solid-state reaction method is employed in the preparation of Bi 2 Se 3 and (Bi 1− x Sb x ) 2 Se 2.7 Te 0.3 polycrystalline pellets, with x = 0.02, 0.04, and 0.06. The sample exhibits a rhombohedral structure with the space group of R m. FESEM and EDAX analysis are used to confirm surface morphology and elemental composition of the produced samples. The thermoelectric measurements for the pristine and co-doped samples were conducted by the physical property measurement system as well as a considerable increase in the Seebeck coefficient of − 115 μV/K is observed for 0.02 doping of the Sb which is 4.2 times greater than as for pristine (S = − 28 μV/K). Higher concentration doping ( x = 0.04, 0.06) has not reflected any Seebeck coefficient advancement. In contrast, the lowest total thermal conductivity at a low-temperature regime (< 50 K) is observed for x = 0.06 doping concentration which at near room temperature increases beyond the pristine thermal conductivity; whereas, x = 0.02, 0.04 doping concentration shows a decrement in total thermal conductivity at low, at room temperature region the values are almost equivalent to that of pristine. The co-doped samples' electrical resistivity is substantially less than pristine sample. The highest power factor of 3 × 10 –4 μW/mK 2 is obtained for the x = 0.02 sample. The highest ZT value for the x = 0.02 sample is almost 28 times more than a pristine sample. We conducted a study where we combined experimental and DFT methods to investigate thermoelectric properties incorporated into pristine and doped with antimony and tellurium on Bi 2 Se 3 . We have employed this combination to investigate the partial density of states, Seebeck coefficient, power factor using the Boltzmann transport equation. Theoretical thermoelectric data were derived and compared to experimental observations. Hence, using combined experimental and theoretical investigations helps to predict with higher accuracy of thermoelectric properties of semiconducting materials.

Crystal structure and thermoelectric properties of bulk polycrystalline (SbxBi1-x)2Se3 alloys

A comprehensive experimental and DFT analysis on thermoelectric properties of Sb, Te co-doped Bi2Se3 polycrystals

Mid-temperature Thermoelectric Performance of Zone-Melted Sb2(Te,Se)3 Alloys Near Phase Transition Boundary

Preparation and Thermoelectric Transport Properties of BiSe and Sb-doped BiSe Single Crystals

Thermoelectric Properties of (Ag2se)1-X(bi2se3)x

Crystal growth and thermoelectric properties of Sn-doped Bi2Se3

Enhanced Thermoelectric Performance of SmS by Se Alloying and Y Doping

Ultralow Thermal Conductivity and Enhanced Thermoelectric Properties Realized in Polycrystalline Bi2S2Se Via Carrier and Microstructure Modulation

Tuning of thermoelectric properties with changing Se content in Sb2Te3

Enhanced Thermoelectric Properties of Sb-doped BiCuSeO Due to Decreased Band Gap

Enhancing thermoelectric behavior of bismuth Selenide crystal via substitution of sulfur and tellurium

Enhanced Thermoelectric Properties in Highly Co-Doped Bi2Se3 by Density-of-State Effective Mass Increase

High Thermoelectric Properties Realized in Earth Abundant Bi2S3 Bulk Materials Via Se and Cl Co-Doping in Solution Synthesis Process

Fabrication and Properties of Bi2S3−xSex Thermoelectric Polycrystals

Preparation and thermoelectric properties of layered Bi<sub>1-<i>x</i></sub>Sb<i><sub>x</sub></i>Se nanocrystalline films

Expand band gap and suppress bipolar excitation to optimize thermoelectric performance of Bi0.35Sb1.65Te3 sintered materials

Thermoelectric properties of Ag-doped bismuth sulfide polycrystals prepared by mechanical alloying and spark plasma sintering

Preparation and Thermoelectric Properties of Layered Bi<sub>1–<i>x</i></sub>Sb<sub><i>x</i></sub>Se Nanocrystalline Films

High Thermoelectric Properties for Sn-doped AgSbSe 2

Promoted thermoelectric performance of (Ag, Na) co-doped polycrystalline BiSe by optimizing the thermal and electrical transports simultaneously

Ultralow Thermal Conductivity and Thermoelectric Properties of Rb2Bi8Se13