Abstract:Internal friction in two kinds of iron-manganese alloy which contain Mn 17.5% and Mn 12.8% respectively and one kind of copper-aluminum alloy containing 13% Al were measured with a torsion pendulum, and internal friction peaks were observed in the temperature range in which the martensite or reverse martensite transformation is taken place. The condition for the appearance of this internal friction peak is that it occurs only when accompanied by the process of martensite-type transformation.Systematic observations were made with iron-manganese alloy containing 17.5% Mn, and it was found that the height of internal friction peak increases with the increase of the rate of heating (or cooling) or the stress, decreases with the increase of the frequency of vibration or the carbon content in the specimen. All these may be explained by the reason that the more the amount of new phase has transformed in one period of vibration, the larger is the internal friction.The mechanism of the internal friction peak was discussed. The conclusion was reached that because of the suddeness of the formation of martensite, the applied external forces due to torsion pendulum may be considered as constant during the time of formation for martensite plates, and since half of the work done by the external forces during the alteration must be lost as confirmed by the calculation of interaction energies between stresses and iuhomogenities, it consequently gives rise to the substantial portion of internal friction. On the other hand, the stress-induced phase transformation also gives rise to a minor portion of internal friction.

Internal Friction Associated with the Premartensitic Transformation and Twin Boundary Motion of Ni50+xMn25−xGa25 (x = 0−2) Alloys

Modulus Softening During the Γ→ɛ Martensitic Transformation in Fe–25Mn–6Si–5Cr–0.14N Alloys

Internal Friction and Modulus Changes Associated with Martensitic and Reverse Transformations in a Single Crystal Ni48.5Mn31.4Ga20.1 Alloy

Internal Friction Behaviors of Ni-Mn-In Magnetic Shape Memory Alloy with Two-Step Structural Transformation

THE BEHAVIOR OF INTERNAL FRICTION ASSOCIATED WITH THE PROCESS OF MARTENSITE-TYPE TRANSFORMATION

Effects of Frequency, Composition, Hydrogen and Twin Boundary Density on the Internal Friction of Ti50Ni50−xCux Shape Memory Alloys

A STUDY OF INTERNAL FRICTION ASSOCIATED WITH THE MARTENSITE TRANSFORMATION AT LOW FREQUENCY

High isothermal internal friction over a large temperature range for dual-phase Ni–Mn–In magnetic shape memory alloy

The internal friction of the pearlitic, bainitic and martensitic transformations in FeNiC alloys

INTERNAL FRICTION ASSOCIATED WITH MARTENSITIC AND PREMARTENSITIC PHASE TRANSFORMATION IN THE Khz AND THE MHz RANGE

Mechanical Behavior and Martensitic Transformation of an Fe–Mn–Si–Al–Nb Alloy

Relaxation of twin boundaries in a Ni2MnGa single crystalline

Study of Stabilization of CuAlBe Alloy During Martensitic Transformation by Internal Friction

Martensitic Microstructure and Its Damping Behavior in Ni52mn16fe8ga24 Single Crystals

The Investigation Of Internal Friction On Antiferromagnetic Transition And Martensitic Transformation In Mn-Fe(Cu) Alloys

Internal-Friction Analysis Of Ni-Ti Alloy Subjected To Temperature-Variation And Under Isothermal Conditions

Internal Friction of Nano-Grained Fe-25%Ni Alloy Bulk

On the internal friction due to the twin boundary-h interaction in martensite

GRAIN BOUNDARY INTERNAL FRICTION IN Al-Mg ALLOYS

Investigation on the Internal friction of reverse martensitic transformation in Fe-Mn-Si based alloys

Internal Friction of Phase Transformations Observed Around Room Temperature in Ga-In-Sn Eutectic Alloys