Abstract:Internal friction in two kinds of iron-manganese alloy which contain Mn 17.5% and Mn 12.8% respectively and one kind of copper-aluminum alloy containing 13% Al were measured with a torsion pendulum, and internal friction peaks were observed in the temperature range in which the martensite or reverse martensite transformation is taken place. The condition for the appearance of this internal friction peak is that it occurs only when accompanied by the process of martensite-type transformation.Systematic observations were made with iron-manganese alloy containing 17.5% Mn, and it was found that the height of internal friction peak increases with the increase of the rate of heating (or cooling) or the stress, decreases with the increase of the frequency of vibration or the carbon content in the specimen. All these may be explained by the reason that the more the amount of new phase has transformed in one period of vibration, the larger is the internal friction.The mechanism of the internal friction peak was discussed. The conclusion was reached that because of the suddeness of the formation of martensite, the applied external forces due to torsion pendulum may be considered as constant during the time of formation for martensite plates, and since half of the work done by the external forces during the alteration must be lost as confirmed by the calculation of interaction energies between stresses and iuhomogenities, it consequently gives rise to the substantial portion of internal friction. On the other hand, the stress-induced phase transformation also gives rise to a minor portion of internal friction.

Investigation of Thermal Hystersis in Ni52.5Mn23.5Ga24 Single Crystals

A Phenomenological Model for Thermally-Induced Hysteresis in Polycrystalline Shape Memory Alloys with Internal Loops

Modulus Softening During the Γ→ɛ Martensitic Transformation in Fe–25Mn–6Si–5Cr–0.14N Alloys

Structural transformation and rheological processes in bulk metallic glass Zr41Ti14Cu12.5Ni10Be22.5

Thermal structural disorder and melting transition in high-angle grain-boundary: a molecular-dynamics study

Influence of Heat Treatments on Martensitic Transformations and Elastocaloric Effect in Two-Phase (β + γ) NiFeGa Alloys

Thermoelastic Intermartensitic Transformation and Its Internal Stress Dependency Inni52mn24

Magnetic Properties and Structural Phase Transformations of NiMnGa Alloys

THE BEHAVIOR OF INTERNAL FRICTION ASSOCIATED WITH THE PROCESS OF MARTENSITE-TYPE TRANSFORMATION

A model of phase transition from austenite to martensite in single-crystal NiMnGa alloys

A STUDY OF INTERNAL FRICTION ASSOCIATED WITH THE MARTENSITE TRANSFORMATION AT LOW FREQUENCY

Magnetic Field-Enhanced Shape Memory Effect in Ni<sub>51.6</sub>Mn<sub>23.4</sub>Ga<sub>25</sub> Single Crystals

Effect Of Low Dc Magnetic Field On The Premartensitic Phase Transition Temperature Of Ferromagnetic Ni2mnga Single Crystals

Composition Dependent Phase Transition and Its Induced Hysteretic Effect in the Thermal Conductivity of Wxmo1-Xte2

Energy penalty, energy barrier and hysteresis in martensitic transformations

Amorphous-to-Cu51Zr14phase Transformation in Cu60Ti20Zr20alloy

Investigation on the Phase-Transition-induced Hysteresis in the Thermal Transport along the C-Axis of MoTe2

Thermally induced changes of structure in Ni$_{50}$Mn$_{25+x}$Ga$_{25-x}$ magnetic shape memory single crystals with very low twinning stress

Stress-Free Two-Way Thermoelastic Shape Memory and Field-Enhanced Strain in Ni52mn24ga24 Single Crystals

Analysis of Mechanical-Thermal Coupled Experiments of Single Crystal TiNi Alloys

High-temperature Metamagnetic Martensitic Transformation in Fairly Mn-rich Ni50−Co Mn37Ga13 (0 ≤x≤ 50) Alloys