Noncircular Tool Fabrication by WEDG Using Electrode Jump Motion and Noncircular Array Holes Drilling

yan qing wang,ji cheng bai,guo zheng zhu

DOI: https://doi.org/10.4028/www.scientific.net/KEM.609-610.715

2014-01-01

Key Engineering Materials

Abstract:Electrode jump motion strategy was adopted to fabricate noncircular tool using wire electrical discharge grinding (WEDG). The machining procedure and electrode jump motion strategy for noncircular tool fabrication were determined through experiments. This approach has been verified by successfully machining of rectangular electrode (38 mu mx38 mu m, 700 mu m length) and D-shaped electrode (diameter 45 mu m, height 42 mu m, 500 mu m length). D-shaped array holes of 6x6 matrix were drilled using corresponding single noncircular tool which was manufactured by the adopted machining approach. The array holes have tight diameter tolerance and height tolerance which are both less than 2 mu m, and positioning errors are both less than 1 mu m in the direction of the X, Y-axes.