Abstract:The template for naoimprint lithography having a nano-sized structure was usually fabricated by traditional lithography such as extreme ultraviolet (EUV) lithography, focused ion beam (FIB) lithography, electron beam (EB) lithography. However, these approaches are always time-consuming and inefficiency which limits the potential application in nanoimprint lithography. To find a simple and low-cost method to fabricate the mold for nanoimprint lithography, and to improve the application in nanoimprint lithography have become the research focus. Instead of being formed by traditional lithography, the anodic aluminum oxide (AAO), with highly regular structures and high pore density, is the mold to achieve periodic structures for nanoimprint lithography. In this work, we successfully transfer a 2D nanoporous array structure to the Si surface via the nanoimprint lithography and AAO. The pore diameter and the interpore distance of the porous silicon (PS) are well consistent with that of AAO template. The interval, the diameter, and the height of the hexagonal array structure are 350-560 nm, 170-480 nm, and 200 nm, respectively. We have tested the Raman spectrum under the excitation by lasers of wavelength 514 nm. According to the results, two samples each exhibits a peak at 520 cm 1 and no frequency shift is observed with the Si characteristic Raman peak, indicating that the PS was not extensively damaged by the ICP etching process. Raman intensity in the structured Si is almost enhanced by a factor of 12 as compared with the case on polished Si, which will greatly benefit the application of Si-based optical devices. Thus, we have realized the replica of the PS template and obtained a nanopillar soft template via the hot embossing lithography.

Ultrahigh Precision Low-Cost Pinpointed SiO2 Patterns Nanofabrication by Using Traditional MEMS Fabrication Processes

Ultra-high Precision Nano Additive Manufacturing of Metal Oxide Semiconductors Via Multi-Photon Lithography

CMOS compatible pinpointed fabrication of nanoscale silicon oxide islands array

Fabrication of in Situ Ultrathin Anodic Aluminum Oxide Layers for Nanostructuring on Silicon Substrate

Method for Fabricating Micro/Nanostructures Via Scanning Probe Microscope and Anisotropic Wet Etching

Fabrication of 2D silicon nano-mold by side etch lift-off method

Unconventional Lithography for Patterned Nanomaterials

Single-Mask Fabrication of Sharp SiOx Nanocones

Fabrication of Large-Area Nanostructures Using Cross-Nanoimprint Strategy

Achieving a sub-10 nm nanopore array in silicon by metal-assisted chemical etching and machine learning

A low-cost fabrication method of nanostructures by ultraviolet proximity exposing lithography

A Low-Cost Method of Fabricating Hybrid Micro-Nano Fluidic Chip by Double-Layer PDMS Mold and UV–thermal Nanoimprinting

A Low-Cost and High-Efficiency Method for Four-Inch Silicon Nano-Mold by Proximity UV Exposure

Fabrication of silicon-based multilevel nanostructures via scanning probe oxidation and anisotropic wet etching

Versatile Approach of Silicon Nanofabrication without Resists: Helium Ion-Bombardment Enhanced Etching

Study on Porous Silicon Template for Nanoimprint Lithography

Novel 3-D Device Fabrication Process in Micro-Electronic Mechanical System Based on Nano-Imprint Lithography

Sustainable Fabrication and Transfer of High‐Precision Nanoparticle Arrays Using Recyclable Chemical Pattern Templates

Fabrication of SiCN MEMS by UV Lithography of Polysilazane

Time-Efficient High-Resolution Large-Area Nano-Patterning of Silicon Dioxide

Micro/Nanoscale Structure Fabrication by Direct Nanoimprinting of Metallic and Semiconducting Nanoparticles