Abstract:In the current work, the effect of nano-sized Sn (50 nm)/Sr partial replacement on the superconducting properties such as crystal structure, quality of intra- and intergrain boundary coupling, dc electrical resistivity, and dc magnetization in the Bi-2212 ceramic superconductors were investigated. Ceramic superconductors with nominal composition of Bi 2 Sr 2- x (Sn) x Ca 1 Cu 1.75 Na 0.25 O y where x = 0.25, 0.30, 0.35 and 0.40 were prepared by solid-state reaction method and characterized by powder X-ray diffraction (XRD), dc electrical resistivity, scanning electron microscopy (SEM) and magnetic hysteresis (M–H) measurements. Phase examination of by XRD indicated that the doping of x = 0.25 ratio nano-sized SnO 2 to the strontium sites improved the formation of the Bi-2212 high-temperature superconducting phase. SEM micrographs showed that the morphological structure of all samples consisted of plate-like grains, which were separated from each other by grain boundaries, indicating the Bi-2212 superconducting phase. The highest superconductivity transition temperature among the samples was measured as the T c onset = 86 K at x = 0.25 in Bi 2 Sr 2- x (Sn) x Ca 1 Cu 1.75 Na 0.25 O y . M–H loops of the Bi 2 Sr 2- x (Sn) x Ca 1 Cu 1.75 Na 0.25 O y sample at x = 0.25 ratio is larger compared to other examples, indicating improvement intergrain connectivity as well as enhanced flux pinning centers. In addition, the critical current ( J c ) values of the samples were calculated from M–H measurement using Bean's critical current model. The best J c values were obtained as 570 A/cm 2 at 15 K, which is a relatively high value for BSCCO superconductors with polycrystalline structure.

Effect of Partial Melting Parameters on the Microstructures and Critical Current Density of Bi-2212 Thick Films

The Preparation and Characterization of Bi-2212 Film on Ag Substrate by Dip-Coating Method

Effect of Pre-Treatment on the Microstructure and Superconducting Properties of Bi-2223/Ag Tapes

PREPARATION OF Bi2Sr2Ca1Cu2Ox SUPERCONDUCTING FILMS ON Ag WIRES BY DIP-COATING METHOD

The influence of the first heat-treatment on the critical current density of (Bi,Pb)-2223/Ag superconducting tapes

Microstructure and Critical Current Density of Bi-2212 Single- and Multi-filamentary Wires with Overpressure Heat Treatment Processing

Effects of Annealing Temperature on the Structures, Ferroelectric and Magnetic Properties of Aurivillius Bi5ti3feo15 Polycrystalline Films

Improving phase transformation and superconducting performance of Bi-2223 tapes via Cu addition

Effects of the Cooling Rate on the Microstructure and Properties of (Bi,Pb)-2223/Ag Tapes

Preparation and electrical properties of ultra-thin Bi2212 films by sol-gel method

The Influence of Synthesis Parameters on Microstructures and Superconducting Properties of MgB2 Bulks

Effect of Fired Temperature on Microstructure and Superconductivity of MOD-YBCO Thin Films

The influences of powder processing variables on the properties of Bi-2223/Ag tapes

PREPARATION OF BiPbSrCaCuO SILVER CLAMP THICK FILM AND TRANSPORT CURRENT CHARACTERISTIC

Improvement in electrical properties of Bi-2212 superconducting materials substituted with large-scale nano-sized tin

Phase purity and surface morphology of high-Jc superconducting Bi2Sr2Ca1Cu2O8+δ thin films

Effect of post-annealing on critical current density of (Bi,Pb)-2223/Ag tapes

Nanoscale characterization of the doped SrZrO3 nanoparticles distribution and its influence on the microstructure of Bi2Sr2CaCu2O8+δ film

The Effect of Hot Isostatic Pressure on the Microstructure and Critical Current of Bi-2223/Ag Superconducting Tapes

Post Annealing Of Bi-2223/Ag Superconductor Tapes

Influence of Partial Melting Temperature on Structure and Superconducting Properties of YBCO Film by Non-fluorine MOD