Abstract:The development of concrete corrosion in new sewer pipes undergoes an initiation process before reaching an active corrosion stage. This initiation period is assumed to last several months to years but the key factors affecting the process, and its duration, are not well understood. This study is therefore focused on this initial stage of the corrosion process and the effect of key environmental factors. Such knowledge is important for the effective management of corrosion in new sewers, as every year of life extension of such systems has a very high financial benefit. This long-term (4.5 year) study has been conducted in purpose-built corrosion chambers that closely simulated the sewer environment, but with control of three key environmental factors being hydrogen sulfide (H2S) gas phase concentration, relative humidity and air temperature. Fresh concrete coupons, cut from an industry-standard sewer pipe, were exposed to the corrosive conditions in the chambers, both in the gas phase and partially submerged in wastewater. A total of 36 exposure conditions were investigated to determine the controlling factors by regular retrieval of concrete coupons for detailed analysis of surface pH, sulfur compounds (elemental sulfur and sulfate) and concrete mass loss. Corrosion initiation times were thus determined for different exposure conditions. It was found that the corrosion initiation time of both gas-phase and partially-submerged coupons was positively correlated with the gas phase H2S concentration, but only at levels of 10 ppm or below, indicating that sulfide oxidation rate rather than the H2S concentration was the limiting factor during the initiation stage. Relative humidity also played a role for the corrosion initiation of the gas-phase coupons. However, the partially-submerged coupons were not affected by humidity as these coupons were in direct contact with the sewage and hence did have sufficient moisture to enable the microbial processes to proceed. The corrosion initiation time was also shortened by higher gas temperature due to its positive impact on reaction kinetics. These findings provide real opportunities for pro-active sewer asset management with the aim to delay the on-set of the corrosion processes, and hence extend the service life of sewers, through improved prediction and optimization capacity.

A Rapid, Non-Destructive Methodology to Monitor Activity of Sulfide-Induced Corrosion of Concrete Based on H2S Uptake Rate

Impact of Fluctuations in Gaseous H2S Concentrations on Sulfide Uptake by Sewer Concrete: the Effect of High H2S Loads

Identification of controlling factors for the initiation of corrosion of fresh concrete sewers.

Wastewater-Enhanced Microbial Corrosion of Concrete Sewers.

A New Corrosion Sensor To Determine The Start And Development Of Embedded Rebar Corrosion Process At Coastal Concrete

Study on the Real-Time Dynamic Monitoring of Corrosion Rate of Reinforcement in Carbonation Environment

Monitoring of Concrete Structure Damage Caused by Sulfate Attack with the Use of Embedded Piezoelectric Transducers

Modeling Sulfide Production in Full Flow Concrete Sewers Based on the HRT Variation of Sewerage.

Corrosion of reinforcing steel in concrete sewers

Applicability Study on Accelerated Corrosion Methods of Steel Bars in Concrete Structure

Application of Non-Destructive Technology in Evaluating Concrete to Sulfate Attack

Effective Monitoring of Corrosion in Reinforcing Steel in Concrete Constructions by a Multifunctional Sensor

THE CORROSION MONITORING USING RESISTANCE-PROBE METHOD IN THE CEMENT MOTAR AND COMPARING WITH ELECTROCHEMISTRY-PROBE METHOD

Study On Distribution Of Steel Corrosion Products In Concrete Structures

In Situ Exploration of the Sulfidogenic Process at the Water-Sediment Interface in Sewers: Mechanism and Implications

THE STATE OF THE ART OF CONCRETE STRUCTURE DURABILITY MONITORING AND RESTORATION

Proportioning Study for Low-carbon Sulfate-resistant Concrete by Microbial Corrosion Testing

Corrosion Monitoring of Reinforcing Steel in Concrete by Electrochemical Sensors

Full-scale investigation of in-situ iron and alkalinity generation for efficient sulfide control

Evaluation of Data-Driven Models for Predicting the Service Life of Concrete Sewer Pipes Subjected to Corrosion.

A Monitoring Technique for Wet H2S Corrosion in Propane Tank