Abstract:Concrete structure is usually affected by sulfate and magnesium salt in soil water environmental. In order to explore anti-erosion properties of cement concrete and high-performance concrete mixed with slag powder after immersed in solution with sulfate and magnesium salt, the study designed three water-binder ratio treatments and two slag powder content treatments. After mixing with water, 1050 specimens (10 mm×10 mm×60 mm) were prepared and incubated in conditions of 20℃ and moisture≥9.5% for 28 d. Then, they were immersed in five different solutions with different sulfate and magnesium concentrations for determine anti-erosion coefficient and microstructure of the specimens during erosion. The results showed that: The cement had many pores with large pore size when water-binder ratio was 0.50, and the maximum diameter of pore reached 372.5μm. The improvement of the pore structure was not obvious when the water-binder ratio decreased to 0.35. When the pure cement concrete specimens was immersed in solution with 2500 mg/L SO42- and 1400 mg/L magnesium2+ for 4 months. The pores of specimens were full of hydration products such as CaSO4·2H2O, 3CaO·Al2O3·3CaSO4·32H2O (AFt), and a small amount of Mg(OH)2 and MgO?SiO2?H2O, which could lead to cracks in concrete, peeling off the side parts, even being crisp and surface slurry loss seriously. After 2 months, the erosion coefficient showed a downward trend with erosion duration and was below 0.85, indicating a limited anti-erosion capacity of silicon concrete. When the concrete was added with slag powder, the pore numbers became small and pore size was small. The largest pore size of concrete with water-binder ratio of 0.35 and 0.30 was only 1/7 and 1/8 times as that of concrete with water-binder ratio of 0.50. Meanwhile, the content of Ca(OH)2 was reduced. The concrete structure became loose, which was more obvious for specimens with low water-binder ratio. After 12 months of erosion in solution of sulfate and magnesium salt (20250mg/L SO42-and 2800mg/L Mg2+), the edge of specimen did not have erosion products and crystals of MgSO4·7H2O, Na2SO4·10H2O, Mg2(OH)3Cl·4H2O, and the corrosion resistance coefficient was still more than 0.85. It suggested that slag powder can significantly improve the anti-erosion properties of high performance concrete formulated by 32.5 silicate cement. Therefore, when cements were used for environment with solutions including 13000 mg/L SO42- and 1400 mg/L Mg2+, or 20250 mg/L SO42- and 2800 mg/L Mg2+, the water-binder ratio of concrete should not be greater than 0.35 and 0.30, respectively, while slag powder content was appropriate from 40% to 45%.The study could provide data support and theoretical basis for concrete preparation and application in irrigation engineering (dam foundation, gates infrastructure and channels etc.) and greenhouse concrete foundation engineering.

Proportioning Study for Low-carbon Sulfate-resistant Concrete by Microbial Corrosion Testing

Effect of modified supplementary cementitious material on performance of mortar and concrete in marine environment

Investigating the sulfate resistance of mortars with multiple mineral admixtures in ammonium-magnesium sulfate solution

Degradation Mechanisms of Chloride Contaminated Cast-in-Situ Concrete Partially Exposed to Magnesium-Sulfate Combined Environment

Experimental study of the deterioration mechanism of concrete under sulfate attack in wet-dry cycles

Sulfate attack on concrete with mineral admixtures

Effect of Seawater on Hydration and Sulfate Resistance of Noncement Mortars

A study of chloride binding capacity of concrete containing supplementary cementitious materials

Degradation Mechanism of Concrete Subjected to External Sulfate Attack: Comparison of Different Curing Conditions

Wastewater-Enhanced Microbial Corrosion of Concrete Sewers.

Microstructure characteristics of concrete after erosion of magnesium salts and sulfates

Deterioration Mechanisms of Ultra-High-Performance Concrete Under Various Sulfuric Acid and Sulfate Attack Conditions

Impact of Fluctuations in Gaseous H2S Concentrations on Sulfide Uptake by Sewer Concrete: the Effect of High H2S Loads

Study on the Oil Well Cement-Based Composites to Prevent Corrosion by Carbon Dioxide and Hydrogen Sulfide at High Temperature

Sulphate Corrosion Mechanism of Ultra-High-Performance Concrete (UHPC) Prepared with Seawater and Sea Sand

Mechanical Properties and Chloride Penetration Resistance of Concrete Combined with Ground Granulate Blast Furnace Slag and Macro Synthetic Fiber

Deterioration Process of Concrete Exposed to Internal Sulfate Attack

Roles of fly ash, granulated blast-furnace slag, and silica fume in long-term resistance to external sulfate attacks at atmospheric temperature

Durability and mechanism of high-salt resistance concrete exposed to sewage-contaminated seawater

Effect of sulfate attack on multiple interfacial transition zones of high-belite sulfoaluminate cement recycled concrete