Abstract:Cross-axis sensitivity of single-axis optomechanical accelerometers, mainly caused by the asymmetric structural design, is an essential issue primarily for high performance applications, which has not been systematically researched. This paper investigates the generating mechanism and detrimental effects of the cross-axis sensitivity of a high resoluion single-axis optomechanical accelerometer, which is composed of a grating-based cavity and an acceleration sensing chip consisting of four crab-shaped cantilevers and a proof mass. The modified design has been proposed and a prototype setup has been built based on the model of cross-axis sensitivity in optomechanical accelerometers. The characterization of the cross-axis sensitivity of a specific optomechanical accelerometer is quantitatively discussed for both mechanical and optical components by numerical simulation and theoretical analysis in this work. The analysis indicates that the cross-axis sensitivity decreases the contrast ratio of the interference signal and the acceleration sensitivity, as well as giving rise to an additional optical path difference, which would impact the accuracy of the accelerometer. The improved mechanical design is achieved by double side etching on a specific double-substrate-layer silicon-on-insulator (SOI) wafer to move the center of the proof mass to the support plane. The experimental results demonstrate that the modified design with highly symmetrical structure can suppress the cross-axis sensitivity significantly without compromising the sensitivity and resolution. The cross-axis sensitivity defined by the contrast ratio of the output signal drops to 2.19%/0.1g from 28.28%/0.1g under the premise that the acceleration sensitivity of this single-axis optomechanical accelerometer remains 1162.45V/g and the resolution remains 1.325 mu g. (C) 2016 Optical Society of America

Design of Optimal Fast Scanning Trajectory for the Mechanical Scanner of Measurement Instruments

Fast Scanning Mode and Its Realization in a Scanning Acoustic Microscope

Accurate mechanical-optical theoretical model of cross-axis sensitivity of an interferometric micro-optomechanical accelerometer

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

Optimal Control Algorithm for Optical Path Scanning Control System Based on Relative Performance Error

Minimizing cross-axis sensitivity in grating-based optomechanical accelerometers.

TSP Solution for Adaptive Scanning Paths in Long-Range SPM Measurements

Resonant Scanning Design and Control for Fast Spatial Sampling

Dynamic Error Modeling and Compensation of a Scanning Probe on CMM

Afm with the Slope Compensation Technique for High-Speed Precision Measurement of Micro-Structured Surfaces

Multi Scan Mode Atomic Force Microscope with Improved Properties and High Applicability

Ideal Scan Path for High-Speed Atomic Force Microscopy

A New Centering Method of the Measuring Probe for Spiral Scanning-Based Surface Profile Measurement Systems

Note: Symmetric Modulation Methodology Applied In Improving The Performance Of Scanning Tunneling Microscopy

Efficient Calibration of a Scanning Probe on CMM

Large-area high-speed scanning probe microscopy using legacy scanners

Non-equidistant Scanning Path Generation for the Evaluation of Surface Curvature in Metrological Scanning Probe Microscopes

A Novel Atomic Force Microscope with High Stability and Scan Speed

Software controlling algorithms for the system performance optimization of confocal laser scanning microscope.

A Method for High-Frequency Mechanical Scanning Ultrasonic Flow Imaging with Motion Compensation