Abstract:An interference-robust reconfigurable receiver in 65-nm CMOS is presented. The front end is split into a low-band (LB) RF path (0.1-1.5 GHz) and a high-band (HB) RF path (1-5 GHz). By utilizing a harmonic recombination technique, the LB path could reject the third/fifth-order harmonic interferences. A tunable narrowband dual-feedback commongate low-noise amplifier (LNA) with LC resonant load provides second-order bandpass filtering to reject the harmonic interferences in the HB path. The RF high-Q bandpass filtering based on the voltage-mode passive mixer and the current-mode low-pass filter in the analog baseband improves the receiver's resilience to out-of-band interferences. A novel power-detectionbased automatic frequency calibration technique is proposed to calibrate the operating frequency of the LNA in the HB path and overcome the effects of process, voltage, and temperature variations. The presented receiver has been implemented in a 65-nm CMOS and consumes 20-76-mW power from 1.2-V power supplies, with a core die area of 5 mm(2). The measured results show that the receiver can tolerate -5-dBm interference with 16-dB noise figure (NF) and achieve 95-105-dB maximum conversion gain and 1.7-8-dB NF over 0.1-5 GHz. It also achieves an average harmonic rejection (HR3)/HR5 of 61/68dB, +7.1/+14.4 dBm in-band/out-of-band input third-order intercept point (OB-IIP3), +71.2-dBm OB-IIP2, and 58.1-dB-image rejection, after the digitally assisted calibrations. The system-level measurements show that the presented receiver achieves 2.1% error vector magnitude (EVM) for 850-MHz Global System for Mobile Communication signals and 5% EVM for band 42 time division duplexing-local thermal equilibrium (LTE) signals, respectively.

A CMOS MedRadio Receiver RF Front-End with a Complementary Current-Reuse LNA

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

A 0.6-V Zero-IF/Low-IF Receiver with Integrated Fractional-N Synthesizer for 2.4-Ghz ISM-Band Applications.

A 0.5-8Ghz Reconfigurable CMOS RF Receiver Front-end for CR and DPA Applications

A C-Band Four-Channel Receiver with Current-Sharing and Large-Signal Multigated-Transistor Techniques in 65-Nm CMOS

Low-power transceiver analog front-end circuits for bidirectional high data rate wireless telemetry in medical endoscopy applications

A Low-Power 2.4-GHz Receiver Front End With a Lateral Current-Reusing Technique

An Ultra-Low Power 400mhz OOK Transceiver for Medical Implanted Applications.

A Low-power 2.4-GHz Receiver Front-end in 55-nm CMOS

A 2.4ghz Low Power Wireless Transceiver Analog Front-End for Endoscopy Capsule System

An 8mw Ultra Low Power 60ghz Direct-Conversion Receiver with 55db Gain and 4.9db Noise Figure in 65nm CMOS

A 5 Ghz 7.2 Db Nf Low Power Direct Conversion Receiver Front-End with Balun Lna

A 320 Μw Multi-Band Receiver with N-Path Switched-Capacitor Networks

A 0.07–3 GHz Wideband Front-End for SDR Receiver with 2.3 Db NF and 12 Dbm IIP<sub>3</sub> in 65 Nm CMOS

A Compact Low Power Current-Mode LNA-Mixer for RF Receiver

An Interference-Robust Reconfigurable Receiver with Automatic Frequency-Calibrated LNA in 65-Nm CMOS

A 13.56-MHz −25-dBm-Sensitivity Inductive Power Receiver System-on-a-Chip With a Self-Adaptive Successive Approximation Resonance Compensation Front-End for Ultra-Low-Power Medical Implants

A Low-Power Monolithic Reconfigurable Direct-Conversion Receiver RF Front-End for 802.11a/b/g Applications

A 1.2V 0.1&#x2013;3ghz Software-Defined Radio Receiver Front-End in 130nm CMOS

0.6‐V 2.1‐mw RF Receiver Based on Passive Mixing and Master–slave Common‐mode Rejection Technique in 65 Nm CMOS