Abstract:This article presents a low-power (LP), compact,wideband (WB) low-noise transconductance amplifier (LNTA)-first receiver (RX) designed for software-defined radios (SDRs).It comprises the LNTA, frequency divider, mixer, and trans-impedance amplifier (TIA). The LNTA utilizes a common gate(CG)-common source (CS) structure without on-chip inductorsand incorporates gm-boosting and current reuse techniques toeffectively reduce power consumption. A novel noise-canceling(NC) strategy is proposed to break the inherent tradeoff betweeninput impedance matching, noise figure (NF), and gain. Thedivider adopts a windmill structure based onNANDgates, while25% duty-cycle quadrature clocks drive the double-balancedpassive mixer. The third-order filtering TIA is based on a three-stage pseudo-differential operational transconductance amplifier(OTA). It implementsRCand feedforward (FF) compensationtechniques to attain a 3.25-GHz unity gain loop bandwidth(BW) and 68-dB loop gain. Fabricated in a 40-nm LP CMOStechnology, the chip features 38-dB conversion gain, 50-MHzbaseband (BB) BW, 3.5-dB NF, and in-band (IB) output third-order intercept point of up to 40 dBm. The RX operates over afrequency range of 0.1-5.5 GHz. It consumes 36 mW of staticpower in the RX signal path and 15 mW of dynamic powerin the local oscillator (LO) path at 5 GHz. The core area isonly 0.1 mm(2).

A Compact Low Power Current-Mode LNA-Mixer for RF Receiver

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

A Low-Power 2.4-GHz Receiver Front End With a Lateral Current-Reusing Technique

A Gm-boosted and current peaking wideband merged LNA and mixer

A Low Power Highly Linear Cmos Current Mode Up-Conversion Mixer

Design of a Low Power Current-Driven Passive Mixer

A Differential Low-Voltage High Gain Current-Mode Integrated RF Receiver Front-End

Low Voltage, Low Power, Downconversion Folded-Switching Mixer With Current-Reuse Technology

A 2.1–2.5 GHz high linearity and low noise down-conversion active mixer

A CMOS MedRadio Receiver RF Front-End with a Complementary Current-Reuse LNA

A 320 Μw Multi-Band Receiver with N-Path Switched-Capacitor Networks

Design of a High Frequency Low-Power LNA

A 0.18 μm mixer merged with LNA exploiting noise cancellation

A <inline-formula> <tex-math notation="LaTeX">${K}$ </tex-math></inline-formula>-Band High-Gain and Low-Noise Folded CMOS Mixer Using Current-Reuse and Cross-Coupled Techniques

A Wideband Cmos Current-Mode Down-Conversion Mixer for Multi-Standard Receivers

A 2.4ghz Low Power Highly Linear Mixer For Direct-Conversion Receivers

A Low Power and High Gain Current-Reused LNA Using Cascaded L-type Input Matching Network.

A Low Voltage Current-reuse Quadrature Down-conversion Mixer for WSN Application

A Low Power Direct Conversion Receiver RF Front-End with High In-Band IIP2/IIP3 and Low 1/f Noise

A Low-Power, Compact, 0.1–5.5-Ghz, 40-Dbm IB OIP3 LNTA-First Receiver for SDR