Abstract:Carbon nanotube field-effect transistors (CNT FETs) have been demonstrated to exhibit high performance only through low-temperature fabrication process and require a low thermal budget to construct monolithic three-dimensional (M3D) integrated circuits (ICs), which have been considered a promising technology to meet the demands of high-bandwidth computing and fully functional integration. However, the lack of high-quality CNT materials at the upper layer and a low-parasitic interlayer dielectric (ILD) makes the reported M3D CNT FETs and ICs unable to provide the predicted high performance. In this work, we demonstrate a multilayer stackable process for M3D integration of high-performance aligned carbon nanotube (A-CNT) transistors and ICs. A low-kappa (similar to 3) interlayer SiO2 layer is prepared from spin-on-glass (SOG) through processes with a highest temperature of 220 C-degrees, presenting low parasitic capacitance between two transistor layers and excellent planarization to offer an ideal surface for the A-CNT and device fabrication process. A high-quality A-CNT film with a carrier mobility of 650 cm(2) V-1 s(-1) is prepared on the ILD layer through a clean transfer process, enabling the upper CNT FETs fabricated with a low-temperature process to exhibit high on-state current (1 mA mu m(-1)) and peak transconductance (0.98 mS mu m(-1)). The bottom A-CNT FETs maintain pristine high performance after undergoing the ILD growth and upper FET fabrication. As a result, 5-stage ring oscillators utilizing the M3D architecture show a gate propagation delay of 17 ps and an active region of approximately 100 mu m(2), representing the fastest and the most compact M3D ICs to date.

3-D matrix nano-wire transistor fabrication on silicon substrate

Vertically Stacked Silicon Nanowire Transistors Fabricated by Inductive Plasma Etching and Stress-Limited Oxidation

Monolithic Three‐dimensional Integration of Aligned Carbon Nanotube Transistors for High‐performance Integrated Circuits

III&#x2013;V 4D Transistors

Top-down Fabricated Silicon-Nanowire-based Field-Effect Transistor Device on a (111) Silicon Wafer.

Facile 3D Integration of Si Nanowires on Bosch-etched Sidewalls for Stacked Channel Transistors

Silicon Nano-Wire Fabricated by Boe Silicon Etching

Fabrication of Conducting Si Nanowire Arrays

Fabrication of Vertically Stacked Single-Crystalline Si Nanowires Using Self-Limiting Oxidation

Nanotube and Nanowire Transistors

Top-down fabrication of sub-30 nm monocrystalline silicon nanowires using conventional microfabrication

3D Electronics: 3D Sidewall Integration of Ultrahigh‐Density Silicon Nanowires for Stacked Channel Electronics (adv. Electron. Mater. 7/2019)

3D Sidewall Integration of Ultrahigh‐Density Silicon Nanowires for Stacked Channel Electronics

Fabrication of Graphoepitaxial Gate-All-Around Si Circuitry Patterned Nanowire Arrays Using Block Copolymer Assisted Hard Mask Approach

Anisotropy Enhancing Vertically Aligned Silicon-Germanium Nanowire

III-V Gate-all-around Nanowire MOSFET Process Technology: from 3D to 4D

A facile nanowire fabrication approach based on edge lithography

Ultra-Confined Catalytic Growth Integration of Sub-10 Nm 3D Stacked Silicon Nanowires Via a Self-Delimited Droplet Formation Strategy.

Three-dimensional Vertical ZnO Transistors with Suspended Top Electrodes Fabricated by Focused Ion Beam Technology

In-plane Silicon Nanowires for Field Effect Transistor Application

Self-aligned Multi-Channel Silicon Nanowire Field-Effect Transistors