Abstract:In gas turbines, the stator wells play a key role in the efficiency of the turbomachine. The research for performance gains requires a good understanding and an accurate modeling of the flows and heat transfers occurring in these areas. Within the framework of the European program main annulus gas path interaction (MAGPI) WP1, a two-stage axial turbine test rig provided an experimental database used to validate the computational fluid dynamics (CFD) models. The aim of this study is to setup a numerical methodology using the CFD solver ANSYS Fluent to accurately predict the conjugate heat transfer in the stator well area. The validation of the methodology relies on thorough comparison of the results with the MAGPI WP1 experimental temperature/pressure measurements. A geometry with axial cooling injection through lock plate slot was chosen. A Reynolds-averaged Navier–Stokes (RANS) three-dimensional sectorized CFD model of the turbine with conjugate heat transfer was used. It includes main gas path, cavities with labyrinths, disks rotor, the casing, and the nozzle guide vanes (NGV). Mixing planes are placed between the static and rotating frames. Different influences (mesh, turbulence model, thermal boundary conditions, radial labyrinths clearances) were studied and compared with experimental data. As a baseline, the first calculations were performed with a cooling flowrate chosen so that hot gas ingresses from the main stream into the stator well cavity. Good agreements between predicted and measured temperatures/pressures were observed, especially in the vicinity of the stator well. Discrepancies were spotted at the first rotor hub endwall and at the upstream wheelspace and will be discussed. Two other cooling configurations were conducted, one with cooling air exiting from the disk rim cavity to the main gas path and the other with the lowest cooling flowrate and so the highest ingress. Finally, the turbine performance under nonadiabatic conditions has been evaluated with an appropriate efficiency definition.

Numerical Simulation and Experimental Investigation of Velocity Fields in a Rotating Disc Contactor

Physical Modelling and Numerical Simulation of Velocity Fields in Rotating Disc Contactor Via Cfd Simulation and Ldv Measurement

Hydrodynamics And Mass Transfer Performance In A Modified Rotating Disc Contactor

Study on velocity fields of rotating disc contactor with different scales by computational fluid dynamics

Research, Development and Industrial Application of New Rotating Disc Contactor

Simulation Methodology Development for Rotating Blade Containment Analysis

Hydrodynamics and Mass Transfer Performance of a Modified Rotating Disc Contactor (MRDC)

Numerical simulation of cylinder orientation through a rotating straight expansion duct

Theoratical study on scaling up of a rotating disc contactor (RDC)

Numerical Investigation of Flows Between Rotating Disks

Numerical Simulation of Turbulent Taylor-Couette Flow with High Taylor Number and Large Radius Ratio in High-Speed Canned Motor Pump Internals

Numerical Investigation of Rotating Detonation Combustion in Annular Chambers

CFD Simulations of the Air/Water Two-phase Flow in an Annular Centrifugal Contactor

Numerical and Experimental Study on Rod-Fastened Rotor Dynamics Using Semi-Analytical Elastic-Plastic Model

Flow and Heat Transfer in a Rotating Disc Cavity With Axial Throughflow at High Speed Conditions

Coupled Fluid-Thermal-Solid Simulation of Axial Through-Flow Rotating Cavities

Numerical and Experimental Investigation on Thermohydrodynamic Performance of Turbocharger Rotor-Bearing System

CFD simulation of liquid flow characteristics in a rotor-stator spinning disc reactor

Numerical Investigations of Flows and Heat Transfer in Turbine Disk Cavities

Experimental and computational investigation on flow characteristics of rotating cavities with high inlet pre-swirl axial throughflow

Experimental study on the intensive swirling flows in a cyclone section