Abstract:Abstract Scale-up studies of fluidized beds are important for numerous fields. Fluidization in a multi-ring inclined nozzle spout-fluid bed (MRIN spout-fluid bed) is one of the most critical factors that affect the coating efficiency and uniformity of tri-structural isotropic (TRISO) nuclear particles in the fluidized bed chemical vapor deposition (FB-CVD) process. In this work, the flow pattern similarity principle was proposed to scale up a specially designed spout-fluid bed, which was aimed at maintaining the gas-solid contact efficiency, and was validated by electrical capacitance tomography (ECT) measurements. First, the traditional ECT method was developed for the specially designed MRIN spout-fluid bed according to the filling method. Then, the reconstruction algorithms were updated using the alternating direction multiplier method (ADMM) by introducing optimization constraints. The fluidization laws were investigated for different superficial gas velocities and distributor structures. We found that the gas distributor structure affected the merge point of the jets, which played an essential role in fluidization pattern changes. The statistically-based coefficient of variation (Cv) was proposed to distinguish the different flow patterns. Multi-ring spouting was then selected as a typical flow pattern for good fluidization and mixing, where the Cv ranged from 0.25 to 0.65. Then, the optimal design principles for the enlarged spout-fluid bed gas distributor were obtained. We determined that a smaller nozzle diameter (0.71 d 0 ), larger nozzle spacing (1.12 x 0 ), and slightly inclined angle (1.50 θ 0 ) could improve fluidization, and that nozzle spacing was the most important factor. This study may be beneficial for the industrial design of the FB-CVD process and for the fabrication of high-density nuclear fuel particles. Additionally, it could be presented to a more general audience for scaling-up fluidized beds with a complex distributor, which would be beneficial for the fluidization research community.

Theoratical study on scaling up of a rotating disc contactor (RDC)

Study on velocity fields of rotating disc contactor with different scales by computational fluid dynamics

Hydrodynamics And Mass Transfer Performance In A Modified Rotating Disc Contactor

Research, Development and Industrial Application of New Rotating Disc Contactor

Physical Modelling and Numerical Simulation of Velocity Fields in Rotating Disc Contactor Via Cfd Simulation and Ldv Measurement

Hydrodynamics and Mass Transfer Performance of a Modified Rotating Disc Contactor (MRDC)

Effect Of The Scale-Up Process On The Reactor Performance Within The Riser: Simulation Using Ozone Decomposition

Study on Scale-Up of Anaerobic Fermentation Mixing with Different Solid Content

Experimental Study on the Coupling Size Effects in the Ring Compression Test

Numerical Simulation and Experimental Investigation of Velocity Fields in a Rotating Disc Contactor

Scale-Up Study on the Performance of Annular Pulsed Disc-And-Doughnut Columns

Study on Flow Field in Capacity Regulating Actuator for Reciprocating Compressor

A numerical scale-up study of annular fluidized bed reactor with high centrifugal acceleration

Progresses of study and application on extraction columns

Experimental and Numerical Investigation on the Scaling-Up of Microsieve Dispersion Mixers

Study of Fluid-to-fluid Scaling for Upward Pipe Flows of Supercritical Fluids Using Direct Numerical Simulation

CFD simulation of liquid flow characteristics in a rotor-stator spinning disc reactor

Study on Hydrodynamics and Mass Transfer Characteristic of a New Gas-liquid Reactor

Fluid-to-fluid Scaling of Heat Transfer to Mixed Convection Flow of Supercritical Pressure Fluids

Experimental study on the scale-up of a multi-ring inclined nozzle spout-fluid bed by electrical capacitance tomography

Strategy for Scaling‐up of a Microsieve Dispersion Reactor