Abstract:Many dynamic simulations of a rotor with a journal bearing employ non-linear fluid-film lubrication models and calculate the bearing coefficients at each time step. However, calculating such a simulation is tedious and computationally expensive. This paper presents a simplified dynamic simulation model of a vertical rotor with tilting pad journal bearings under constant and variable (transient) rotor spin speed. The dynamics of a four-shoes tilting pad journal bearing are predefined using polynomial equations prior to the unbalance response simulations of the rotor-bearing system. The Navier–Stokes lubrication model is solved numerically, with the bearing coefficients calculated for six different rotor speeds and nine different eccentricity amplitudes. Using a MATLAB inbuilt function (poly53), the stiffness and damping coefficients are fitted by a two-dimensional polynomial regression and the model is qualitatively evaluated for goodness-of-fit. The percentage relative error (RMSE%) is less than 10%, and the adjusted R-square () is greater than 0.99. Prior to the unbalance response simulations, the bearing parameters are defined as a function of rotor speed and journal location. The simulation models are validated with an experiment based on the displacements of the rotor and the forces acting on the bearings. Similar patterns have been observed for both simulated and measured orbits and forces. The resultant response amplitudes increase with the rotor speed and unbalanced magnitude. Both simulation and experimental results follow a similar trend, and the amplitudes agree with slight deviations. The frequency content of the responses from the simulations is similar to those from the experiments. Amplitude peaks, which are associated with the unbalance force (1 × Ω) and the number of pads (3 × Ω and 5 × Ω), appeared in the responses from both simulations and experiments. Furthermore, the suggested simulation model is found to be at least three times faster than a classical simulation procedure that used FEM to solve the Reynolds equation at each time step.

Numerical and Experimental Study on Rod-Fastened Rotor Dynamics Using Semi-Analytical Elastic-Plastic Model

Dynamic Modeling and Experimental Modal Analysis for the Central Rod-Fastened Rotor With Hirth Couplings Based on Fractal Contact Theory

Modeling a Two-Span Rotor System Based on the Hamilton Principle and Rotor Dynamic Behavior Analysis

3-D Dynamic Elastic–plastic FEA for Rotating Disk Indirect Bar–bar Tensile Impact Apparatus: Numerical Analysis for the Generation of Mechanically-Filtered Incident Stress Pulses

Dynamic Modeling of Tie-bolt Rotors via Fractal Contact Theory and Virtual Material Method

Investigation on the dynamic behaviors of a rod fastening rotor based on an analytical solution of the oil film force of the supporting bearing

Nonlinear dynamic of the rod-fastening combined rotor system with rub-impact based on the Stribeck friction model

Strength Analysis for Surface-mounted Permanent Magnet Rotor in High-Speed Motor

Study on the Semi-numerical and Semi-analytical Solutions of the Dynamics Equation of an Aero-engine Rotor System with ERSFD

Dynamic modeling and simulation of a flexible-rotor ball bearing system

A Simplified Numerical Elastic-Plastic Contact Model for Rough Surfaces

Nonlinear Dynamic Modeling of Rotor System Supported by Angular Contact Ball Bearings

Simulation of Rotor'S Axial Rub-Impact in Full Degrees of Freedom

Dynamic Characteristics of Rub-Impact on Rotor System with Cylindrical Shell

Finite Element Modeling and Dynamic Analysis of Rotating Disc and Drum Connected by Bolted Joints

Rub-impact dynamic analysis of a dual-rotor system with bolted joint structure: Theoretical and experimental investigations

Dynamics of a Rod-Fastened Rotor Considering the Bolt Loosening Effect

Speed-Dependent Bearing Models for Dynamic Simulations of Vertical Rotors

Dynamic analysis of the variable stiffness support rotor system with elastic rings

Numerical Studies on Time-Varying Stiffness of Disk-Drum Type Rotor with Bolt Loosening

Modeling approach for flexible shaft-disk-drum rotor systems with elastic connections and supports