Abstract:In this paper, a finite element (FE) model for rotating-flexible shaft-disk-drum (SDR) system with bolted joints is established based on beam-shell-spring hybrid elements by in-house codes. Rotation-induced effects, that is, centrifugal effect, initial tension, gyroscopic moments, and geometric non-linearity due to large deformation are taken into account. Besides, fixed interface mode synthesis method is applied to improve solving efficiency. The proposed model is verified by the results from literature and experiments. Finally, the effects of the number of bolts, rotating speed, connecting stiffness, and the location of disk-drum on the natural characteristics of SDR system are investigated. The main conclusions are summarized as follows: (1) Modes dominated by different components have different sensitivities to the variations of the number of bolts. (2) The analysis of Campbell diagram indicates that frequency veering phenomenon can be found among the shaft bending (SB) mode, disk transverse (DT) mode, disk swing (DS) mode and drum one-circumferential wave (1CW) mode in low-order modes, and the disk nodal diameter (ND) mode always couples with the drum CW mode in high-order modes. (3) The change of axial connecting stiffness will cause the coupling vibration between the disk and drum, while the change of transverse shear stiffness not only causes the coupling vibration between the disk and the drum, but also the coupling vibration among the shaft, disk and drum. (4) The change of disk-drum location can affect the modes associated with the shaft SB and cause frequency veering phenomena. The disk ND modes and the drum CW modes are not coupled with the shaft SB modes when the number of ND and CW are greater than 2.

Numerical Studies on Time-Varying Stiffness of Disk-Drum Type Rotor with Bolt Loosening

Bolt loosening at rotating joint interface and its influence on rotor dynamics

Analyzing Performance of Automobile Brake Drum in 3D Thermo-elastic Coupling Field

Dynamic modeling and stability analysis of a rotor-bearing system with bolted-disk joint

Finite Element Modeling and Dynamic Analysis of Rotating Disc and Drum Connected by Bolted Joints

Analytical model of bolted disk–drum joints and its application to dynamic analysis of jointed rotor

Effect of Bolt Number on Joint Stiffness of Disc and Drum Connected by Bolted Joints

Numerical and experimental analysis of the effect of eccentric phase difference in a rotor-bearing system with bolted-disk joint

Numerical and experimental investigations on dynamic behaviors of a bolted joint rotor system with pedestal looseness

Thin-layer element method for multi-stage rotor bolt loosening identification

Modal Frequency and Stability of Rotor System Supported by Viscoelastic Elastomeric Dampers

Research on the Influence of Disc–Drum Connection Bolt Preloading Rotor Assembly Modal Characteristics and Diagnosis Technology

Dynamics of a Rod-Fastened Rotor Considering the Bolt Loosening Effect

Dynamics Analysis Of A Rigid Rotor System With Drum On Supports

Nonlinear Dynamic Analysis for a Jeffcott Rotor Considering Varying Connection Stiffness of Bolted Joint

Measured and investigated nonlinear dynamics parameters on bolted flange joints of combined rotor

Coupling vibration characteristics of the shaft-disk-drum rotor system with bolted joints

Modeling and dynamic analysis for rotors with curvic-coupling looseness

Dynamics Behavior of Multi-Disk Flexible Rotor System with Transverse Crack

Stiffness and geometry characteristics of flange connection with bolt failure and its influence on rotor dynamics

Study on the influence of joint parameters on nonlinear dynamics of a rotor system