Abstract:Large gas turbines often utilize dual-rotor structures to improve efficiency. To facilitate manufacture and maintenance, the large rotor systems are typically constructed by connecting components made from different materials together through the bolted joint. In this work, a dynamic model of a dual-rotor system with bolted joint included in the high-pressure (HP) rotor is established based upon the finite element theory of Timoshenko beam element, as well as taking into account the bearing forces and fixed-point rubbing fault. To evaluate the influence of rubbing faults on the dynamic behavior of a dual-rotor system, this study analyzed the response characteristics of the rotor under the cases of the LP rotor and the HP rotor subjected to the rubbing fault, respectively. In order to further reveal the effect of bolted joint structure on the system response while rubbing fault occurs, piecewise linear bending stiffness is also considered in this study. The nonlinear vibration responses of the bolted joint dual rotor-bearing system are studied through numerical simulation. Effect of rotor–stator contact stiffness and the occurrence of rubbing faults at the low-pressure (LP) rotor and the HP rotor are investigated through frequency-amplitude curves, waterfall diagrams, time-domain responses, and bending stiffness of the bolted joint. The results indicate that the presence of rubbing faults, whether occurring at the LP rotor or the HP rotor, leads to a decrease in the critical speed. Furthermore, under a rubbing fault, the bending stiffness of the bolted joint enters the stiffness softening region earlier and exhibits a wider range, which is exacerbated with increased contact stiffness. This phenomenon is considered one of the main causes of system response instability. Finally, the experimental studies are carried out on a bolted joint dual-rotor test rig to validate the numerical simulation results.

Numerical and experimental analysis of the effect of eccentric phase difference in a rotor-bearing system with bolted-disk joint

Dynamic modeling and stability analysis of a rotor-bearing system with bolted-disk joint

Modeling a Two-Span Rotor System Based on the Hamilton Principle and Rotor Dynamic Behavior Analysis

Analytical model of bolted disk–drum joints and its application to dynamic analysis of jointed rotor

Dynamic Behavior Analysis of a Rotor-Bearing-Squeeze Film Damper Coupling System with Bearing Outer Race Localized Defect

Vibration Analysis of a Nonlinear Rotor-Bearing-seal System

Study on the influence of joint parameters on nonlinear dynamics of a rotor system

Numerical Studies on Time-Varying Stiffness of Disk-Drum Type Rotor with Bolt Loosening

Nonlinear Dynamic Analysis for a Jeffcott Rotor Considering Varying Connection Stiffness of Bolted Joint

Dynamic effects of the initial skewness of the inertial principal axis on the rotor with bolted joint

Numerical and experimental investigations on dynamic behaviors of a bolted joint rotor system with pedestal looseness

Modeling and Nonlinear Dynamic Characteristics Analysis of Fault Bearing Time-Varying Stiffness-Flexible Rotor Coupling System

Bolt loosening at rotating joint interface and its influence on rotor dynamics

Lubrication and stability analysis of nonlinear rotor-bearing system

Finite Element Modeling and Dynamic Analysis of Rotating Disc and Drum Connected by Bolted Joints

Effect of Bolt Number on Joint Stiffness of Disc and Drum Connected by Bolted Joints

Coupling vibration characteristics of the shaft-disk-drum rotor system with bolted joints

Measured and investigated nonlinear dynamics parameters on bolted flange joints of combined rotor

A measurement method for support characteristics of active magnetic bearings based on multi-DOF rotor system model

Rub-impact dynamic analysis of a dual-rotor system with bolted joint structure: Theoretical and experimental investigations

Dynamic Coefficients of Radial Magnetic Bearings and Coupling of Magnetic Force and Magnetic Moment: A Simulation Study