Abstract:The influence of M1 (lower level Cu) line width on stress-induced voiding (SIV) behavior of copper dual damascene interconnects was investigated by stress migration test at 200 degrees C and finite element analysis (FEA). M I line width under study ranged from 200 run to 1000 nm, whereas the M2 line width was fixed to be 3 mu m. The normalized change in resistance indicated that the via-line structures with larger M1 line width were more susceptible to SIV Failure analysis utilizing focus ion beam (FIB) showed that voids were fon-ned in the via bottom region for samples with M I line width less than 280 nm. However, voids were found at the Si3N4/M1 Cu interface near the via bottom if M I line width is larger than 280 nm.To further understand the underlying physics of SIV, three dimensional finite element models were built to Simulate the hydrostatic stress distribution in the via-line structures. It was found that the stress gradient in the length direction, grad sigma(1), was not sensitive to M1 line width, however, the stress gradient in the line width direction, grad sigma(w), was found to increase with M I line widths. It is thus proposed that in addition to the active diffusion volume, it is the grad sigma(w) that further favors the migration of voids (or vacancies) along the Si3N4/M1 Cu interface and subsequent accumulation of the voids near the via bottom leading to a much higher resistance change at larger M1 widths. (c) 2005 Elsevier B.V. All rights reserved.

Optimized Copper Line Aspect Ratio by Monte Carlo Method

Modeling of Carbon Nanotube Interconnects and Comparative Analysis with Cu Interconnects

Comparative Study on Multilayer Graphene Nanoribbon (MLGNR) Interconnects

High‐frequency Modeling of Cu‐graphene Heterogeneous Interconnects

Electrical Modeling of Three-Dimensional Carbon-Based Heterogeneous Interconnects

Modeling and Characterization of Carbon-Based Heterogeneous Interconnects for 3-D Ics

Modeling and Characterization of Cu-Graphene Heterogeneous Interconnects

Mini-Review: Modeling and Performance Analysis of Nanocarbon Interconnects

Electrothermal Cosimulation of 3-D Carbon-Based Heterogeneous Interconnects

Understanding the Impact of Surface Engineering, Structure, and Design on Electromigration Through Monte Carlo Simulation and In‐Situ SEM Studies

Mechanisms of Scaling Effect for Emerging Nanoscale Interconnect Materials

Monte carlo simulation of cu-resistivity considering size-effects

Optimization of Effective Parameters for Improving Adhesion Strength of Copper Nanowire Surface Fastener

The Effect of Line Width on Stress-Induced Voiding in Cu Dual Damascene Interconnects

Numerical Simulation of Optimizing Plating Uniformity of Interconnect Circuits on Printed Circuit Boards

Optimal repeater insertion for nano‐interconnects in current‐mode signalling scheme

Monte Carlo simulation of Cu-resistivity

Nano-Modification Fine-Pitch All-Copper Interconnect Technology Based on Spark Ablation

The Partition Algorithm for Interconnect Analysis in Carbon Nanotube Based ASICs

Pursuit of Future Interconnect Technology with Aligned Carbon Nanotube Arrays [Nanopackaging]

Electrical Resistivity Calculations for Copper Nanointerconnect