Abstract:This letter presents a compact low temperature co-fired ceramic (LTCC) receiver front-end module integrating 9 building blocks.The receiver is a twice-frequency-conversion front-end module with image rejection, works at X-band, consists of an X-band embedded image rejection band-pass filter (BPF), an Lband multilayer image rejection quasi-ellipitc BPF, two monolithic microwave integrated circuit (MMIC) low noise amplifiers (LNAs), two intermediate frequency (IF) amplifiers, two mixers, a IF BPF, and some lumped passive components.All MMICs are mounted into premaking cavities in the three layers LTCC substrate of the top surface, and the interconnection between MMICs and surface microstrip-line is established by bond wires.A multilayer five-pole Chebyshev interdigital BPF is developed as the first image rejection filter, and a four-pole quasi-elliptic BPF composed of stepped-impedance hairpin resonator and miniaturized hairpin resonators that can be coupled through the apertures on the common ground plane is proposed for as the second image rejection filter.The developed X-band receiver front-end module is fabricated using twenty layers LTCC dielectric substrate, which has a compact size of 30 × 20 × 20 mm 3 (including the metal cavity).The measured receiver gain and noise figure are more than 32 dB and less than 4 dB, respectively.The first and second image rejection is better than 28 dB and 40 dB, respectively.Compared with conventional receiver front-end module using hybrid microwave integrated circuit (HMIC) technology, the proposed receiver module not only has compact size, but also has good performance.

Design and implementation of a 5GHz RF receiver front-end in LCP based system-on-package module with embedded chip technology

A 0.5-8Ghz Reconfigurable CMOS RF Receiver Front-end for CR and DPA Applications

Chip Package Co-design of 5ghz RF Receiver Front-End Using Multichip Module Technology

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

A 54-67-ghz Low-Power Highly-Integrated Transceiver in 65-Nm CMOS for FMCW Radar Applications

Design of a Low Power 60ghz OOK Receiver in 65nm CMOS Technology

Chip-package co-design of a concurrent LNA in system-on-package for multi-band radio applications

A 100mhz-2ghz Wireless Receiver In 40-Nm Cmos For Software-Defined Radio

A compact dual-band direct-conversion CMOS transceiver for 802.11a/b/g WLAN

Chip-package co-design of common emitter LNA in system-on-package with on-chip versus off-chip passive component analysis

SoP Design on Liquid Crystal Polymer Substrate for 5 GHz RF Receiver Front-End Module

High performance RF-microwave multilayer integrated components for wireless applications

Design of efficient filter on liquid crystal polymer substrate for 5 GHz wireless LAN applications

A COMPACT X-BAND RECEIVER FRONT-END MODULE BASED ON LOW TEMPERATURE CO-FIRED CERAMIC TECHNOLOGY

Design and Implementation of a Dual-Band RF SiP Module Based on Package-on-Package Technology

A Low Power 3–5 GHz CMOS UWB Receiver Front-End

A 2.5D Integrated L Band Receiver Based on High Resistivity Si Interposer

Performance evaluation and receiver front-end design for on-chip millimeter-wave wireless interconnect

Design And Implementation Of A Compact Dual-Band Rf System-In-Package Module

Design and Implementation of RF Front-End Module Based on 3D Heterogenous-Integrated Wafer-Level Packaging

A 5 Ghz 7.2 Db Nf Low Power Direct Conversion Receiver Front-End with Balun Lna