Abstract:It is extremely difficult to obtain high output power with silicon based processes, which presents one of the greatest challenges for realizing fully integrated transceivers, especially at millimeter-wave frequencies. For this reason, various power combining methods have been proposed to achieve higher power levels.In this paper, a novel power combining method suitable for millimeter-wave applications is presented. The power combining network is synthesized in package utilizing wafer level packaging technology, with an array of power sources of moderate output power capability assumed to be distributed on chip, which means applying further combining in addition to existing on-chip power combining scheme for potentially even higher output power is possible.The power combining network is composed of more basic power combining units, each consisting of one substrate integrated waveguide (SIW) resonator coupling four lambda/4 standing-wave resonators, which can be synthesized using two quarter-wavelength vertical vias with one end open and the other end shorted. For power combining purpose, the open end of each lambda/4 resonator is connected to the differential output of one on-chip power source, while the shorted end is realized using one of the two metal plates of the SIW resonator. The coupling between the SIW resonator and lambda/4 resonators is through slotting on the metal plate to allow magnetic leakage so that oscillation in lambda/4 resonators will excite the SIW resonator to oscillate. As the quality factor of the SIW resonator is much larger than those of lambda/4 resonators, energy is mainly confined in the cavity of the SIW resonator so that power combing is achieved.Example design for 60 GHz application is detailed in the paper with simulation results using commercial CST software showing the effectiveness of the power combining method.

High performance RF-microwave multilayer integrated components for wireless applications

Blueprint and integration of vastly efficient 802.11A WLAN front-end

Chip Package Co-design of 5ghz RF Receiver Front-End Using Multichip Module Technology

Novel Millimeter-Wave Power Combining Utilizing Wafer Level Packaging Technology

A Compact 2-18Ghz Ultra-Wideband Frequency-conversion T/R Module Based on a 3D Heterogeneous Integrated Process

A 54-67-ghz Low-Power Highly-Integrated Transceiver in 65-Nm CMOS for FMCW Radar Applications

A Highly-integrated Non-magnetic Passive Circulator Based on Rotary Traveling-wave Oscillator and Spatio-temporal Conductivity Modulation in 130 Nm CMOS

A 0.6V 32.5mw Highly Integrated Receiver for 2.4ghz ISM-Band Applications

Design of efficient filter on liquid crystal polymer substrate for 5 GHz wireless LAN applications

20 . 6 A 0 . 6 V 32 . 5 mW Highly Integrated Receiver for 2 . 4 GHz ISM-Band Applications

Design and implementation of a 5GHz RF receiver front-end in LCP based system-on-package module with embedded chip technology

RF CMOS technology for MMIC

Design And Implementation Of A Compact Dual-Band Rf System-In-Package Module

Design and Implementation of RF Front-End Module Based on 3D Heterogenous-Integrated Wafer-Level Packaging

Performance evaluation and receiver front-end design for on-chip millimeter-wave wireless interconnect

Heterogeneous Integration of Millimeter-wave Transceivers: Fabrication, Components and System

Novel On-Chip Passive Circuits for Rf, Microwave, Millimeter-Wave and Sub-Thz Applications

Chip-package co-design of common emitter LNA in system-on-package with on-chip versus off-chip passive component analysis

On-chip Versus Off-Chip Passives Analysis in Radio and Mixed-Signal System-on-package Design

Design of a New Millimeter-Wave 3D Stacked RF Front-End System Level Package

A Highly Integrated C-Band Feedback Resistor Transceiver Front-End Based on Inductive Resonance and Bandwidth Expansion Techniques