Abstract:A three-terminal ballistic junction (TBJ) is a device in which three quantum point contacts (or electron waveguides) are coupled via a ballistic region [1]. Theoretical and experimental studies [15] have shown that the TBJs exhibit a novel electrical property which has potential applications in nanoelectronics, such as rectification, harmonic generations, and logic functions. The modeling has also shown that the effect is observable at room temperature, it is robust against asymmetry, and it does not depend on the angle between the left and right branches of the TBJ [1]. Here, based on our recent investigations, we will demonstrate that various nanoelectronic devices can be fabricated using the TBJs as building blocks. In particular, the results of our recent design, fabrication, modeling and measurements of TBJ diodes and transistors, TBJ frequency multipliers, and TBJ logic gates will be presented and discussed. The results of experiments to be presented have mainly been obtained based on devices made from high-quality InGaAs quantum well materials, but the properties of the devices have also been observed in experiments with other herterostructure materials. Figure 1(a) shows an SEM image of a typical T-shaped TBJ device made from GaInAs/InP quantum well system using electron beam lithography and wet chemical etching. The dimension of the active area of the devices is about 200 nm. The measured electron mean free path in this quantum-well material varies from a few microns at 0.3 K to∼ 130 nm at room temperature. Thus, the electron transport in our devices is expected to be ballistic or quasi-ballistic up to room temperature. The characteristics of the output voltage VC s a function ofV , with VL = V andVR = −V , were measured. The obtained results are compared with the prediction of Ref. [1] and a good agreement is found. Furthermore, room-temperature diode and triode behaviors of the TBJs as predicted in Ref. [4] were experimentally demonstrated [see Fig. 1(b)]. Several integrated devices designed by using TBJs as building blocks were also fabricated and characterized. As an example, we show a TBJ-based logic device that was made by integration of a T-shaped TBJ and a point contact on high-mobility GaInAs/InP quantum well materials. The 4 × 4 μm scanning electron microscope image of the device and the measurement circuit setup are shown in Fig. 2(a). The output voltage measured at room temperature as a function of the two input voltages is shown in Fig. 2(b). It can be seen that the device performs the logic NAND function. It can also be seen that the device has a gain, i.e., the amplitude of the output voltage is larger than the amplitude of the input voltages. In addition, this device, in the present circuit configuration, can also be used as a frequency multiplier. Several other functional and logic devices have also been designed with the TBJs as building blocks and have been fabricated and characterized. To conclude, the TBJs have been fabricated and characterized. Various functional devices, such as frequency multipliers and logic gates, designed with the TBJs as building blocks have been realized. We emphasize that all these devices with potential applications in nanoelectronics can be fabricated with ultrasmall dimensions by a single-step lithography process and function at room temperature.

A Novel Frequency-Multiplication Device Based on Three-Terminal Ballistic Junction

A Novel Frequency-Doubling Device Based on Three-Terminal Ballistic Junction

Novel Nanoelectronic Device Applications Based on the Nonlinearity of Three-Terminal Ballistic Junctions

Frequency Mixing and Phase Detection Functionalities of Three-Terminal Ballistic Junctions

Novel Room-Temperature Functional Analogue And Digital Nanoelectronic Circuits Based On Three-Terminal Ballistic Junctions And Planar Quantum-Wire Transistors

Nonlinear Operation of Gainas/Inp-Based Three-Terminal Ballistic Junctions

Novel nanoelectronic triodes and logic devices with TBJs

Three-terminal Ballistic Junctions as Building Blocks for Nanoelectronic Devices

A Novel SR Latch Device Realized by Integration of Three-Terminal Ballistic Junctions in InGaAs/InP

Ju l 1 99 9 Ballistic Single-Electron Quputer

Tunable Nonlinear Current–voltage Characteristics of Three-Terminal Ballistic Nanojunctions

Nonlinear Electrical Properties Of Si Three-Terminal Junction Devices

A Novel Device Principle for Nanoelectronics

Nanoimprint Technology for Fabrication of Three-Terminal Ballistic Junction Devices in GaInAs/InP

Photonic integrated circuits fabricated using quantum well intermixing

Ballistic electronic devices

A Novel Architecture for Frequency Doubler Featuring Compact 3-D Stacked Packaging and Four Multiplying Structures

A Silicon Cluster Based Single Electron Transistor with Potential Room-Temperature Switching

Broadband parametric amplification for multiplexed SiMOS quantum dot signals

A Novel Balanced Frequency Tripler With Improved Power Capacity for Submillimeter-Wave Application

Nanoimprint Lithography for Fabrication of Three-Terminal Ballistic Junctions in Inp/Gainas