Abstract:The linearity of active mixers is usually determined by the input transistors, and many works have been proposed to improve it by modified input stages at the cost of a more complex structure or more power consumption. A new linearization method of active mixers is proposed in this paper; the input 1 dB compression point (IP1dB) and output 1 dB compression point (OP1dB) are greatly improved by exploiting the "reverse uplift" phenomenon. Compared with other linearization methods, the proposed one is simpler, more efficient, and sacrifices less conversion gain. Using this method, an ultra-high-linearity double-balanced down-conversion mixer with wide IF bandwidth is designed and fabricated in a 130 nm SiGe BiCMOS process. The proposed mixer includes a Gilbert-cell, a pair of phase-adjusting inductors, and a Marchand-balun-based output network. Under a 1.6 V supply voltage, the measurement results show that the mixer exhibits an excellent IP1dB of +7.2~+10.1 dBm, an average OP1dB of +5.4 dBm, which is the state-of-the-art linearity performance in mixers under a silicon-based process, whether active or passive. Moreover, a wide IF bandwidth of 8 GHz from 3 GHz to 11 GHz was achieved. The circuit consumes 19.8 mW and occupies 0.48 mm2, including all pads. The use of the "reverse uplift" allows us to implement high-linearity circuits more efficiently, which is helpful for the design of 5G high-speed communication transceivers.

A Highly Linear Short-Wave Broadband Double-Balanced Mixer

A Highly Linear Short-Wave Ultra-Wideband Balanced Amplifier

A 27 - 57 GHz Down-conversion Mixer with Bulk Injection Technique

A High Performance 2-Ghz Direct-Conversion Front End with Single-Ended RF Input in 0.13 Um CMOS

An Ultra-Low Power K band Balanced Frequency Doubler with a Novel Current-reused Structure

Modified Broadband Ruthroff-Type Transmission Line Transformer Balun for Isolation-Enhanced Passive Mixer Design

Design of a 24-30-GHz High-Linearity Down-Conversion Mixer

High-Linearity Double-Balanced Up-Conversion Mixer with an Active Balun Based on InGaP/GaAs HBT Technique

A 2.1–2.5 GHz high linearity and low noise down-conversion active mixer

A UWB Mixer with a Balanced Wide Band Active Balun Using Crossing Centertaped Inductor

A 62–85-Ghz High Linearity Upconversion Mixer with 18-Ghz IF Bandwidth

A 24-to-30 GHz Ultra-High-Linearity Down-Conversion Mixer for 5G Applications Using a New Linearization Method

A High Performance Double-Balanced Gilbert Mixer with Active Loads for 2.4-GHz ISM Band Application

Wideband Subharmonic Mixer In Bilateral Finline At U-Band

Design of W-Band Wide Intermediate Frequency Fundamental Mixer Based on Finline

A high gain, wide band (2–10 GHz), and low noise active balun merged folded mixer for the full-band UWB application

A Wideband Mixer Designed with Low Conversion Loss Through the Entire W-Band

Design of A X-Band Image Rejection Balanced Mixer

A Reusable Superheterodyne Dual-Band Down-Conversion Mixer With Hybrid Linearity-Enhanced Technique for 5G Non-Contiguous Multiband NR

A High Conversion Gain Wideband Mixer Design for UWB Applications

A K-Band High-Gain and Low-Noise Folded CMOS Mixer Using Current-Reuse and Cross-Coupled Techniques