Abstract:III-nitrides based high electron-mobility transistors (HEMTs) are well-known excellent candidates for high-power, radio-frequency (rf) and high-temperature applications. However, HEMTs have to face the essential issues of high gate leakage current and drain current collapse (gate-lag), which inevitably limits the device performances and reliability. Here, we fabricate an optimized AlGaN/GaN metal-oxide-semiconductor high electron mobility transistor (MOS-HEMT), by using HfZrOx (HZO) as a gate dielectric, that can improve the interfacial and transport properties. Compared to the conventional high permittivity (high-kappa) gate dielectric HfO2 which has attracted wide attention in recent years, the concentrations of interface traps and the inside fixed oxide defects are obviously reduced by using high quality HZO layer. Through the dielectric engineering of HZO, the MOS-HEMT with HZO dielectric shows an enhanced DC output performance with an increase of 54% at the optimal working condition, which is indeed much higher than that of the HfO2 MOS-HEMT (40%). And the HZO MOS-HEMT exhibits a higher I-on/I-off ratio of 10(6), an excellent subthreshold swing (SS) of 85 mV/decade, and a higher voltage swing (GVS). The gate leakage is reduced by nearly 8 orders of magnitude compared to the conventional unpassivated HEMTs (conv. HEMT) at the gate voltage of -5 V. These results are mainly caused by the replacement of the low-height Schottky barrier (SB) and the reduction of interface traps density. In order to further investigate the interfacial and electric properties of HZO MOS-HEMT, the dynamic gate/drain voltage and high-frequency capacitance-voltage (C-V) measurements are both applied. Remarkably, no measurable current collapse and C-V hysteresis are clearly observed, showing the enhanced interfacial and electric performances of the MOS-HEMT with dielectric engineering of HZO.

A high breakdown voltage AlGaN/GaN MOSHEMT using thermal oxidized Al-Ti as the gate insulator

High Breakdown AlGaN/GaN MOSHEMT with Thermal Oxidized Ni/Ti As Gate Insulator

Enhanced Device Performance of AlGaN/GaN HEMTs Using Thermal Oxidation of Electron-Beam Deposited Aluminum for Gate Oxide

Low Leakage Current and High-Cutoff Frequency AlGaN/GaN MOSHEMT Using Submicrometer-Footprint Thermal Oxidized TiO2/NiO As Gate Dielectric

Simulation and analysis of high breakdown voltage AlGaN/GaN MOSHEMTs with TiO2/Al2O3 gate dielectric

CMOS-compatible Ehancement-Mode GaN-on-Si MOS-HEMT with High Breakdown Voltage (930V) Using Thermal Oxidation and TMAH Wet Etching

Enhanced Device Performance Of Algan/Gan High Electron Mobility Transistors With Thermal Oxidation Treatment

High Performance AlGaN/GaN Power Switch with Si3N4insulation

Enhanced Performances of AlGaN/GaN HEMTs with Dielectric Engineering of HfZrOx

High V th and Improved Gate Reliability in P-GaN Gate HEMTs with Oxidation Interlayer

5.3A/400V Normally-off AlGaN/GaN-on-Si MOS-HEMT with High Threshold Voltage and Large Gate Swing

AlGaN/GaN HEMTs with thermal oxidation treatment for microwave power applications

Current-collapse Suppression and Leakage-Current Decrease in AlGaN/GaN HEMT by Sputter-Tan Gate-Dielectric Layer

Algan/Gan Hemts with an Insulated Gate Fabricated by Inductively Coupled Plasma Oxidization

Characteristics of Submicron-Footprint TiO2 Based AlGaN/GaN MOSHEMT on SiC Substrate

Schottky-Contact Technology in InAlN/GaN HEMTs for Breakdown Voltage Improvement

High-performance normally off p-GaN gate high-electron-mobility transistor with In 0.17 Al 0.83 N barrier layer design

High Breakdown Voltage InAlN/AlN/GaN HEMTs Achieved by Schottky-Source Technology

Normally-Off p-GaN Gated AlGaN/GaN MIS-HEMTs with ALD-Grown Al2O3/AlN Composite Gate Insulator

Enhancement-mode GaN-on-Silicon MOS-HEMT using pure wet etch technique

Normally-off GaON/p-GaN Gate HEMTs with Selective Plasma Oxidation: from Structural Characterization, Performance Improvement to Physical Mechanism