Abstract:Abstract This paper presents 3D Fabry–Pérot (FP) cavities fabricated directly onto cleaved ends of low-loss optical fibers by a two-photon polymerization (2PP) process. This fabrication technique is quick, simple, and inexpensive compared to planar microfabrication processes, which enables rapid prototyping and the ability to adapt to new requirements. These devices also utilize true 3D design freedom, facilitating the realization of microscale optical elements with challenging geometries. Three different device types were fabricated and evaluated: an unreleased single-cavity device, a released dual-cavity device, and a released hemispherical mirror dual-cavity device. Each iteration improved the quality of the FP cavity’s reflection spectrum. The unreleased device demonstrated an extinction ratio around 1.90, the released device achieved 61, and the hemispherical device achieved 253, providing a strong signal to observe changes in the free spectral range of the device’s reflection response. The reflectance of the photopolymer was also estimated to be between 0.2 and 0.3 over the spectrum of interest. The dual-cavity devices include both an open cavity, which can interact with an interstitial medium, and a second solid cavity, which provides a static reference reflection. The hemispherical dual-cavity device further improves the quality of the reflection signal with a more consistent resonance, and reduced sensitivity to misalignment. These advanced features, which are very challenging to realize with traditional planar microfabrication techniques, are fabricated in a single patterning step. The usability of these FP cavities as thermal radiation sensors with excellent linear response and sensitivity over a broad range of temperature is reported. The 3D structuring capability the 2PP process has enabled the creation of a suspended FP heat sensor that exhibited linear response over the temperature range of 20 oC –120 oC; temperature sensitivity of ∼50 pm oC −1 at around 1550 nm wavelength; and sensitivity improvement of better than 9x of the solidly-mounted sensors.

Polymeric Turbidity Sensor Fabricated by Laser Direct Writing

Laser Direct Writing Based on Turbidity Sensor Structure

A New Route for Fabricating Polymer Optical Microcavities.

Laser Direct Writing Using Submicron-Diameter Fibers.

Integrative Optofluidic Microcavity with Tubular Channels and Coupled Waveguides Via Two-Photon Polymerization

Miniaturized Optical Fiber Turbidity Sensor for Turbidity Monitoring in Constricted Space

A Microfluidic Sensor for Dynamic Surface Tension Measurement

Fluorescence enhanced biomolecule detection using direct laser written micro-ring resonators

A Low-Cost Portable Optical Fiber-Based Sensor for Water Turbidity Measurement

Design and characterization of a novel turbidity sensor based on quadrature demodulation

Three-Wavelength Fiber Laser Sensor With Miniaturization, Integration for the Simultaneous Measurement of Underwater pH, Salinity, Temperature, and Axial Strain

A Glass-Fiber-Optic Turbidity Sensor for Real-Time In Situ Water Quality Monitoring

Three-dimensional Fabry–Pérot cavities sculpted on fiber tips using a multiphoton polymerization process

Turbidity and RI Dependency of a Polymer Optical Fiber-Based Chromatic Sensor

Femtosecond Laser Direct-Writing On-Chip MZI Temperature Sensor Based on Polymer Waveguides

Four-wave Mixing-Based Photonic Crystal Fiber Microfluid Sensor with Embedded U-shape Microslits

A Novel Micro-Displacement Sensor Based on Double Optical Fiber Probes Made through Photopolymer Materials

Femtosecond Laser Microprinting of a Polymer Optical Fiber Interferometer for High-Sensitivity Temperature Measurement

Two-photon 3D printing optical Fabry-Perot microcavity for non-contact pressure detection

A Novel Kind of Turbidity Sensor and its Measurement Method

Polymer Mems-Based Fabry-Perot Shear Stress Sensor