Abstract:To ascertain the influence of SiC nanowires on sintering kinetics of heterophase ceramics, two composite powders (TaSi2-TaC-SiC and TaSi2-TaC-SiC-SiCnanowire) are fabricated by mechanically activated combustion synthesis of Ta-Si-C and Ta-Si-C-(C2F4) reactive mixtures. Remarkable compressibility is achieved for the TaSi2-TaC-SiC-SiCnanowire composition (green density up to 84% as compared with 45.2% achieved for TaSi2-SiC-TaC) which is attributed to the lubricating effect of residual adsorbed fluorinated carbon (most likely C4F8). The outcomes of pressureless sintering of TaSi2-TaC-SiC and TaSi2-TaC-SiC-SiCnanowire compositions are vastly different; the former experiences no significant densification or grain growth and does not attain structural integrity, whereas the latter achieves relative density up to 93% and hardness up to 11 GPa. The SiC nanowires are not retained in consolidated ceramics, but instead, act as a sintering aid and promote densification and grain growth. Sintering mechanisms of TaSi2-TaC-SiC and TaSi2-TaC-SiC-SiCnanowire powders are analyzed using thermodynamic and ab initio grand potential calculations, as well as the analysis of grain size versus relative density relations. In the case of solid-state sintering, the densification and grain growth in heterophase non-oxide ceramics are governed by the same mechanisms as previously investigated single-phase oxides. The presence of SiC nanowires enhances grain-boundary related diffusion processes due to the high specific surface and aspect ratio of the nanowires. At 1500 °C, where the formation of the transient Si-based liquid phase is thermodynamically viable, only the SiC nanowire-containing composition demonstrated the intense grain coarsening and densification associated with liquid-assisted sintering. This effect can be attributed both to the presence of SiC nanowires and purification of residual oxide impurities due to C2F4-activated combustion synthesis employed for the in situ formation of SiC nanowires.

Influence of Conductive Nano-Tic on Microstructural Evolution of Si3n4-Based Nanocomposites in Spark Plasma Sintering

Optimization of Microstructure to Improve Si3n4 Ceramics with Thermal Conductivity and Mechanical Properties: Effect of Si and Α-Si3n4 Powder Composition

Microstructure and Mechanical Properties of TiN/Si3N4 Nanocomposites by Spark Plasma Sintering (SPS)

Microstructure and Fracture Behavior of Β-Si3n4 Based Nanoceramics

Preparation and Properties of Nano-Sic-Based Ceramic Composites Containing Nano-Tin

Sintering Behavior, Microstructure and Mechanical Properties of Silicon Carbide Ceramics Containing Different Nano-Tin Additive

Spark plasma sintering of TiN ceramics codoped with SiC and CNT

Fabrication, Microstructural Evolution, and Mechanical Properties of SiC/(Hf0.25Ta0.25Zr0.25Nb0.25)C/C Nanocomposites

Fabrication of Si3n4/Sic Nanocomposites by Spark Plasma Sintering of Amorphous Sicn Powders Derived from A Polymeric Precursor

Microstructure and Mechanical Properties of Al<sub>2</sub>O<sub>3</sub>/SiC Nanocomposites Prepared by SPS

Microstructure And Mechanical Properties Of Sic Ceramic Toughened With Tin Nanoparticles

Effect of Nano-Si3n4 Addition on the Microstructure and Mechanical Properties of Ticn-Based Cermets

Effect of Heating Rate on Spark Plasma Sintering of a Nanosized Β-Si3n4-based Powder

Effects of Ti(C, N) addition on the microstructure and mechanical properties of spark plasma sintered Si3N4/Ti(C, N) ceramic tool material

In situ formation of Si3N4–SiC nanocomposites through polymer-derived SiAlCN ceramics and spark plasma sintering

Effect of In Situ Grown SiC Nanowires on the Pressureless Sintering of Heterophase Ceramics TaSi2-TaC-SiC

Effect of spark plasma sintering temperature on the multi-scale microstructure evolution and mechanical properties of Ti 2 AlC/TiAl composites with network architecture

Effect of nano-TiC addition on sinterability and mechanical properties of TiC high temperature ceramics

Fabrication and mechanical evaluation of SiC–TiC nanocomposites by SPS

Effect of Tungsten Carbide on Densification and Mechanical Properties of Silicon Nitride Ceramics by Spark Plasma Sintering

Effects of in situ formed nanostructures on the structure and properties of C/SiOC composites