Abstract:The pressureless sintering was investigated to fabricate dense Si3N4/SiC nanocomposites from commercially available Si nitrided Si3N4 Powder. MgAlO4 + ZrO2 (totally 10 and 15 wt%) or Y2O3+Al2O3 (totally 10.5 and 14 wt%) and 5-30 vol% SiC were used as sintering additives and second phase dispersions, respectively. With increasing SIC content, the density of the composite containing less amount of sintering,additives decreased linearly, while the large amount of sintering additives decreased gradually the density or kept it constant. The composites with higher SiC content presented a relatively smaller Si3N4 grain size, because L Si3N4 grain growth was inhibited by SiC particles that pinned the grain boundary movement. While decrease in strength was observed for the composites with less amount of sintering additives, an improvement of the strength was found for the composites with high amount of sintering additives, The strength change of the composites was consistent with their densification behavior and microstructural observation, Composite with 20 vol%, SiC exhibited high strength up to 1 GPa. With increasing SiC content, hardness increased but toughness decreased. It is concluded that the results of this study provide an economic way to fabricate the Si3N4/SiC nanocomposite with high performance.

Preparation and Properties of Nano-Sic-Based Ceramic Composites Containing Nano-Tin

Sintering Behavior, Microstructure and Mechanical Properties of Silicon Carbide Ceramics Containing Different Nano-Tin Additive

Microstructure And Mechanical Properties Of Sic Ceramic Toughened With Tin Nanoparticles

Preparation and Characterization of Si3n4/Tin Nanocomposites Ceramic Tool Materials

Effect of nano-TiC addition on sinterability and mechanical properties of TiC high temperature ceramics

Study of the mechanical properties, toughening and strengthening mechanisms of Si3N4/Si3N4w/TiN nanocomposite ceramic tool materials

Effect of Nano-Si3n4 Addition on the Microstructure and Mechanical Properties of Ticn-Based Cermets

Preparation and properties of TiN–Si3N4 composites

Microstructure and mechanical properties of SiC nanowires reinforced titanium matrix composites

Nano-sized TiN-reinforced Composites: Fabrication, Microstructure, and Mechanical Properties

Influence of Conductive Nano-Tic on Microstructural Evolution of Si3n4-Based Nanocomposites in Spark Plasma Sintering

Effects of nano-TiCp on the microstructures and tensile properties of TiCp/Al–Cu composites

Microstructure, mechanical properties and strengthening mechanism of in-situ synthesized TiC/6061 nanocomposites

Reinforcing and Toughening Alumina/titania Ceramic Composites with Nano-Dopants from Nanostructured Composite Powders

Effects of nanosized TiCp dispersion on the high-temperature tensile strength and ductility of in situ TiCp/Al-Cu-Mg-Si nanocomposites

Microstructure and mechanical properties of aluminum alloy composites with endogenous nano-TiCp

Densification and Mechanical Properties of Si3N4/SiC Nanocomposite Using Si-Nitrided Si3N4 Powder

Preparation and sintering behaviour of nanostructured alumina/titania composite powders modified with nano-dopants

Microstructure, mechanical properties and strengthening mechanisms of in-situ prepared (Ti5Si3 + TiC0.67)/TC4 composites

Sintering And Enhanced Mechanical Properties Of Densified Multiwalled Carbon Nanotube/Tin Composites

PRESSURELESS SINTERING OF SILICON CARBIDE NANOCOMPOSITE CERAMICS