Abstract:For high temperature superconducting (HTS) dc cables, one key issue is the necessity of using polymer dielectrics with higher dielectric strength at cryogenic temperature in liquid nitrogen. Nanocomposites have played an important role in improving the dielectric properties of epoxy resin (EP). This article investigates on the dc breakdown strength and the surface potential behavior of the epoxy/Al <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sub> O <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">3</sub> nanocomposites (0, 1, 3, 5 wt%) at the room and cryogenic temperatures. Moreover, the trap distributions are analyzed from the surface potential decay (SPD) measurement. The possible effect of the trap distributions on the dc breakdown strength is discussed with the valid results. The measurements show that the dc breakdown strength and the initial surface potential continually increased with the nanoparticle addition up to 3 wt% at both room and cryogenic temperatures, and decreased thereafter. The enhancement of the breakdown strength and the initial potential is also found at cryogenic temperature. Besides, the addition of the nanoparticles decreased the rate of SPD compared with the pure epoxy. It is proposed that the higher trap density and trap level enhances the dc breakdown strength. Interestingly, under the cryogenic environment, the nanoparticles addition significantly affects the trap distributions, which further influences the dielectric strength. The enhanced dc breakdown strength is attributed to the reduced space charge formation, the charge carrier mobility and the energy of the charge carriers within the sample bulk.

Thermal Conductivity Measurement of the Epoxies and Composite Material for Low Temperature Superconducting Magnet Design

Fabrication of Three-dimensional Thermally Conductive Carbon Fibers/Carbon Nanotubes Network Reinforce Epoxy Composites

DC Breakdown and Surface Potential Behavior of Epoxy/Al<sub>2</sub>O<sub>3</sub> Nanocomposites at Cryogenic Temperature

Variable Temperature Thermal Conductivity and Conductance Measurements Using a Gifford-McMahon Cryocooler

Thermal conductivity measurements of solid materials at low temperatures

Measurement of Thermal Conductivity of CFRPs and Thermal Conductance of the Cold-to-Warm Joint at Low Temperatures

Thermal Conductivity of Thermally-Isolating Polymeric and Composite Structural Support Materials Between 0.3 and 4 K

Thermal conductivity measurement of an individual millimeter-long expanded graphite ribbon using a variable-length T-type method

RETRACTED: Development of a Cryogenic Test Bed for High Amperage Critical Current Measurement on High Temperature Superconductor Wire

Properties of selected structural and flat flexible cabling materials for low temperature applications

Numerical Study on Effective Thermal Conductivity of the Compacted Superconducting Magnet

Measurement and Analysis of Thermal Materials in the Thermally Actuated Magnetization Flux Pumping Method

An improved steady-state method for measuring the thermal contact resistance and bulk thermal conductivity of thin-walled materials having a sub-millimeter thickness

Ceramic/Metal Composites with Positive Temperature Dependence of Thermal Conductivity

Transversal Thermal Conductivity of HTS Tapes: Analytical Method vs Measurements

Development of thermal conductivity measurement system based on cryocooler for broad temperature range

Analysis of experimental conditions for simultaneous measurements of transport and magnetotransport coefficients of high temperature superconductors

Effect of Substrate Temperature on Temperature Sensitivity and Magnetoresistance of CrO X N Y Thin Film Cryogenic Sensor

High-Temperature Measurement of Seebeck Coefficient and Electrical Conductivity

Thermal Conductivity Measurement System for Functional and Structural Products