A Back-Illuminated Heterojunctions Ultraviolet Photodetector Based on ZnO Film
Xiangdong Jiang,Dawei Li,Wenjun Yang,Jiming Wang,Xu Lin,Ziqiang Huang
DOI: https://doi.org/10.1117/12.867893
2010-01-01
Abstract:In this paper, we present the investigation of a back-illuminated heterojunctions ultraviolet detector, which were fabricated by depositing Ag-doped ZnO based (ZnO-TiO2) thin film on transparent conductive layer of ITO coated quartz substrate though the reactive radio-frequency (RF) magnetron sputtering at higher oxygen pressure. The p-n junction characteristic is confirmed by current-voltage (I-V) measurements. The turn-on voltage was 6 V, with a low leakage current under reverse bias (-5 V), corresponding values was just 0.2 nA. It is clearly showed the rectifying characteristics of typical p-n junction's rectifier behaviors. The structural, component and UV (365 nm, 1400 mu W/cm(2)) photoresponse properties were explored by X-ray diffraction (XRD), Scanning Electron Microscope (SEM), X-ray energy dispersive spectrometer (EDS) and Tektronix oscilloscope. The results showed that: Ag in substitution form in the ZnO lattice, Ag doping concentration is low, the sample is highly c-axis preferred orientation, With the increase in doped Ag volume, ZnO film of 002 peaks no longer appear. The surface of the Ag doped ZnO based film exhibits a smooth surface and very dense structure, no visible pores and defects over the film were observed. The ultraviolet response time measurements showed rise and fall time are several seconds Level.