A Back-Illuminated Heterojunctions Ultraviolet Photodetector Based on ZnO Film

Xiangdong Jiang,Dawei Li,Wenjun Yang,Jiming Wang,Xu Lin,Ziqiang Huang
DOI: https://doi.org/10.1117/12.867893
2010-01-01
Abstract:In this paper, we present the investigation of a back-illuminated heterojunctions ultraviolet detector, which were fabricated by depositing Ag-doped ZnO based (ZnO-TiO2) thin film on transparent conductive layer of ITO coated quartz substrate though the reactive radio-frequency (RF) magnetron sputtering at higher oxygen pressure. The p-n junction characteristic is confirmed by current-voltage (I-V) measurements. The turn-on voltage was 6 V, with a low leakage current under reverse bias (-5 V), corresponding values was just 0.2 nA. It is clearly showed the rectifying characteristics of typical p-n junction's rectifier behaviors. The structural, component and UV (365 nm, 1400 mu W/cm(2)) photoresponse properties were explored by X-ray diffraction (XRD), Scanning Electron Microscope (SEM), X-ray energy dispersive spectrometer (EDS) and Tektronix oscilloscope. The results showed that: Ag in substitution form in the ZnO lattice, Ag doping concentration is low, the sample is highly c-axis preferred orientation, With the increase in doped Ag volume, ZnO film of 002 peaks no longer appear. The surface of the Ag doped ZnO based film exhibits a smooth surface and very dense structure, no visible pores and defects over the film were observed. The ultraviolet response time measurements showed rise and fall time are several seconds Level.
What problem does this paper attempt to address?