Abstract:ICP power/RF power, operating pressure, and Cl2/BCl3 gas mixing ratio are altered to investigate the effect of input process parameters on the etch characteristics of GaN films. The etch selectivity of GaN over SiO2 and photoresist is studied. Although higher ICP/RF power can obtain higher GaN/photoresist etch selectivity, it can result in faceting of sidewall and weird sidewall profile due to photoresist mask erosion. Etch rates of GaN and SiO2 decrease with the increase of operating pressure, and etch selectivity of GaN over SiO2 increases with the increasing operating pressure at fixed ICP/RF power and mixture component. The highest etch selectivity of GaN over SiO2 is 7.92, and an almost vertical etch profile having an etch rate of GaN close to 845.3nm/min can be achieved. The surface morphology and root-mean-square roughness of the etched GaN under different etching conditions are evaluated by atomic force microscopy. The plasma-induced damage of GaN is analyzed using photoluminescence (PL) measurements. The optimized etching process, used for mesa formation during the LED fabrication, is presented. The periodic pattern can be transferred into GaN using a combination of Cl2/BCl3 plasma chemistry and hard mask SiO2. Patterning of the sapphire substrate for fabricating LED with improved extraction efficiency is also possible using the same plasma chemistry.

Optimization of inductively coupled plasma deep etching of GaN and etching damage analysis

Etching Damage Analysis and Optimization of Inductively Coupled Plasma Etching of GaN

Study on ICP Etching Induced Damage in P-Gan

A Study Of Gan-Based Led Structure Etching Using Inductively Coupled Plasma

Efficient Access to Non-Damaging GaN (0001) by Inductively Coupled Plasma Etching and Chemical–mechanical Polishing

Dry Etching Characteristics of GaN Using Cl2/BCl3 Inductively Coupled Plasmas

Optimized ICP etching process for fabrication of oblique GaN sidewall and its application in LED

Plasma etching of III-V semiconductors and mechanism of crystalline damage

Plasma etching ofⅢ-Ⅴsemiconductors and mechanism of crystalline damage

Characteristics of N-Gan after ICP Etching

Study of Inductively Coupled Plasma Etching GaP in LED Fabrication

Control of Inductively Coupled Plasma Etching GaN Sidewall Profiles and Etch Rate

Impact of Inductively Coupled Plasma Etching Conditions on the Formation of Semi-Polar (\({11\overline{2}2}\)) and Non-Polar (\({11\overline{2}0}\)) GaN Nanorods

The Effect of Inductively Coupled Plasma Etching on the I–V Curves of the Avalanche Photodiode with GaN/AlN Periodically Stacked Structure

Controllable process of nanostructured GaN by maskless inductively coupled plasma (ICP) etching

Pulsed N2 Plasma Surface Treatment for AlGaN/GaN HEMTs Prior to PECVD SiNx Passivation to Reduce Plasma Damage

Characteristics of N-Gan after Cl-2/Ar and Cl-2/N-2 Inductively Coupled Plasma Etching

New Development in Dry Etching of GaN

Nonselective and smooth etching of GaN/AlGaN heterostructures by inductively coupled plasmas

Ultradeep electron cyclotron resonance plasma etching of GaN

ICP Dry Etching ITO to Improve the Performance of GaN-based LEDs