Abstract:It may be a potential way to realize high-efficiency and high-quality local loading forming on the double-action press. However, the deformation characteristics and forming quality of transitional region are the weak link during forming process. In this work, the material flow, deformation inhomogeneity, forming defect of transitional region, and their dependences on the local loading parameters were quantitatively investigated by FE simulation. It is found that due to the constraint clearance, the web material would undergo twice transverse flow with opposite directions successively in two loading steps. This phenomen is basically the same as that in the local loading forming on single-action press, while the extent of transverse material flow on double-action press is greatly smaller. Finally, the transitional region presents different strain distributions in various sub-regions. Region A and region C present a symmetric strain concentration area at rib root, while region B presents a slant strain concentration area at the middle rib. The forming quality on double-action press is better than that on the single-action press. Only a cavum defect at left rib is produced because of the transverse material flow. Constraint clearance plays the most important role in the deformation characteristics and forming quality during the local loading forming on double-action press. The transverse material flow and cavum defect can be suppressed by decreasing the constraint clearance, but the deformation inhomogeneity would increase to some extent at the same time. In addition, the friction factor and radius of left rib are the second significant factors. Increasing the friction factor and radius of left rib is helpful to suppress the transverse material flow and cavum defect, respectively. As far as the forming quality of transitional region is concerned, it is a better way to conduct the local loading forming on double-action press than on single-action press. The results will provide basis for the design of processing parameters in the local loading forming of Ti-alloy rib-web component on double-action press.

Deformation Behavior in the Compression Process of L-shaped Aluminum Alloy Components

Deformation Rule and Mechanism in Compress Process of Aluminium Alloy Square Ring

Deformation Behaviour of the Compressed Square Ring of 7075 Aluminium Alloy

The deformation behavior and processing maps in the isothermal compression of 7A09 aluminum alloy

Deformation Characteristics of Transitional Region During Local Loading Forming of Ti-alloy Rib-Web Component on the Double-Action Press

Investigation of the Diffluence Mechanism of an Aluminium Alloy Ring under Compression

Deformation Division of Metal Flow Behavior During Extrusion Process of 7075 Aluminum Alloy

Diffluence Behaviour of Aluminium Alloy During Ring Compression

Deformation Behavior and Microstructural Evolution During the Semi-Solid Compression of Al–4Cu–Mg Alloy

Plastic Deformation on Hydroforming of Aluminum Alloy Tube with Rectangular Sections

Coupling Deformation of Aluminum Alloy Disk Components During Forging Process

Deformation Behavior in the Uniaxial Tension Process of Aluminum and Aluminum Alloy Sheets under Fluid Pressure

Compression Deformation Behaviors of Sheet Metals at Various Clearances and Side Forces

Deformation Mechanism of Compression of 2024 Al Alloy in Semi-Solid State

Deformation Behavior of Aluminum Alloy during Semi-Solid Compression

SIMULATION OF ALUMINUM FIXTURE PART HOT EXTRUSION PROCESS WITH THE FINITE VOLUME METHOD

Comprehensive study of hot compression behaviors and microstructure evolution of solutionized 6082 aluminum alloy extruded bar

Deformation behavior of Al-6.1Zn-2.8Mg-1.9Cu-0.25Cr alloy during hot compression

Deformation Behaviour and Microstructures of Semi-Solid A356.2 Alloy Prepared by Radial Forging Process During High Solid Fraction Compression

Deformation Zone Distribution of Continuous Extrusion Process

Deformation Modes Coupled Analysis in the Forging Process of Disc-Shaped Components