Abstract:Additional strain increments occur in concrete subject to stress constraints during cold shrinkage, resulting in irregular deformation and reducing the concrete structure’s stability. When an annular concrete structure is subjected to radial pressure, two tensile stress concentration zones will appear at the intersection of the inner wall and the diameter along the pressure direction. When exposed to low temperatures, the total strain in the tensile stress concentration zones is caused by the combined effect of applied stress strain and thermal strain. Then, the thermal strain of the structure can be obtained from the difference between the total strain and the applied stress strain. Gradient cooling was performed after applying radial pressure to the annular concrete using a counterforce device. The applied stress strain and total strain of the tensile stress concentration zones are measured by fiber Bragg grating (FBG) strain sensors fixed along the stress direction. According to the measurement results, the thermal strains of the concrete structure under the stress constraint are extracted to analyze the influence of the tensile stress constraint on the thermal strain of the concrete structure. In the temperature range of −40∘C∼20∘C, the thermal strains of the structure under radial pressures of 1500 N, 2000 N, and 3000 N are extracted, respectively. The thermal expansion coefficients are calculated based on the thermal strain of the structure. The free thermal expansion coefficient of concrete structures fluctuates around 11×10−6/∘C. When the temperature is reduced to 10∘C, the difference between the thermal expansion coefficient under the stress constraint and the free thermal expansion coefficient is the largest. When the temperature is reduced to −20∘C, the thermal expansion coefficients under each stress condition are close to the same. The results show that the stress confinement significantly inhibits the cold shrinkage of the concrete structure, and the inhibitory effect is gradually weakened when the temperature decreases.

STUDY ON THERMAL STRESS OF CONCRETE FRAME STRUCTURES WITH PLANE RINGS

Temperature Field and Stress Field of Prestressed Concrete Box-Girder Bridge

Finite element analysis of temperature effect and crack-control measures for ultra-long concrete structures

Analytical Study of Circular Concrete-Filled Steel Tube Stub Columns under Axial Compression

Thermal Stresses in Rectangular Concrete Beams, Resulting from Constraints at Microstructure, Cross-Section, and Supports

Analysis of Temperature Stress in Bridges Considering Vertical and Transverse Temperature Gradient

Numerical Simulation and Assessment of Self-Induced Tensile Stresses in Steel Ring Restrained Concrete

ANALYSIS OF TRANSVERSE THERMAL STRESS OF LARGE SPAN CONCRETE BOX GIRDER

Evolution Law of Concrete Interface Stress of Rigid-Frame Arch under Construction and Its Impact on Ultimate Load-Bearing Capacity

Simulation Analysis of Thermal Stress of CFST Arch Bridge During Exothermic Hydration Process

Test on Seismic Performance of Frame Structure of Steel Reinforced Concrete Beam and Steel-Tube Encased Concrete Column

Evaluation of shrinkage induced cracking in early age concrete: From ring test to circular column

Stress analysis of concrete slab in high CFRD and measures for improving the stress state

Experimental research on the working stress of measurement on concrete by the ring-hole method

Effect analysis of temperature in the large continuous rigid frame bridge

Evaluation of Cracking Behavior of Concrete at Early-Age Based on Ring Test

ANALYSIS ON THE STRESS PATTERNS OF THE JOINT BETWEEN CONCRETE-FILLED RECTANGULAR STEEL TUBULAR COLUMNS AND STEEL BEAMS

Three-dimensional finite element modeling and theoretical analysis of concrete confined with FRP rings

Analytical Methods for Temperature Field and Temperature Stress of Column Pier under Solar Radiation

Thermally Induced Stresses in Concrete Pavement on Concrete Bridge

Thermal Strain Detection for Concrete Structure Cold Shrinkage under Stress Constraint with FBG