Abstract:To study the evolution of stress on the ring and segment interfaces during the construction process of the concrete encapsulation of the main arch ring in a rigid-frame arch bridge, alongside its impact on the ultimate load-bearing capacity of the main arch ring, a 1:10 scale model experiment was conducted by taking the 600 m Tian'e Longtan Bridge as the prototype. The key cross-section concrete strain data were collected during the entire construction process of the main arch ring via fiber-optic strain sensors, which were used to investigate the stress evolution at ring and segment interfaces. ANSYS APDL was employed to simulate the ultimate bearing capacity under various loading conditions of two different finite element models, which were, respectively, formed segmentally and by single pouring. The results revealed that (1) after the closure of the concrete encapsulation of the main arch ring, the concrete stress in the cross-section exhibits significant stress disparities. At the same cross-section, the level of the web concrete stress can reach 76% of the floor concrete stress, while the roof concrete stress level is less than 20% of the floor concrete stress. (2) At the junction of two adjacent work planes, there are considerable differences in the stress levels of the concrete on both sides. After the closure of the main arch ring, the intersegment stress ratios of the floor, web, and roof concrete are 60~70%, 40~60%, and 0~5%, respectively. (3) Loading conditions remarkably affected the ultimate bearing capacity of the main arch ring. Under mid-span loading and 1/4 span symmetrical loading conditions, compared to single-pour concrete encapsulation, the ultimate bearing capacity of the main arch ring with concrete encapsulated by segmented and ring-divided pouring decreased by 19.16% and 5.23%, respectively, compared to single-pour concrete encapsulation. This suggests that the non-uniformity of stress distribution in the concrete sheath can lead to reductions in the ultimate bearing capacity of the arch ring.

Experimental research on the working stress of measurement on concrete by the ring-hole method

Numerical Analysis of Ultimate Strength of Concrete Filled Steel Tubular Arch Bridges

Experimental Study on Working Stress Measurement of Concrete by Grooving Method

Temperature Field and Stress Field of Prestressed Concrete Box-Girder Bridge

Experimental research on the strength of concrete mearsured by limpet

STUDY OF BEARING CAPACITY AND COMPLETE STRESS-STAIN CURVES FOR CONCRETE FILLED SQUARE STEEL TUBE COLUMNS

Research on In Situ Stress Measurements in Reinforced Concrete Beams Based on the Core-Drilling Method

A concrete quality control in the construction process

Axial stress measurement of concrete with nonlinear ultrasonic harmonic method

Experimental Study on the Development of Surrounding Soil Stress During XCC Pile Installation in Sand

Stress Analysis of Concrete Materials Based on Finite Element Analysis

A PRELIMINARY RESEARCH ON USING CORE RING METHOD TO MEASURE RESIDUAL STRESS IN CONCRETE PAVEMENT SURFACE

New Method of Measuring the Real Stress of Reinforced Concrete

EXPERIMENTAL STUDY ON STRESS-STRAIN CURVES OF THE EXISTING CONCRETE

Evolution Law of Concrete Interface Stress of Rigid-Frame Arch under Construction and Its Impact on Ultimate Load-Bearing Capacity

Study on Stress Characteristics of Multi-arch Tunnel Lining under Weak Surrounding Rock Conditions Based on Field Measurement

Numerical Simulation and Assessment of Self-Induced Tensile Stresses in Steel Ring Restrained Concrete

Statistical Inversion Approach for Stress Estimation Based on Strain Monitoring in Continuously Pre-Stressed Concrete Beams

Data analysis on residual stresses measured in concrete beams

Determination of stress relaxation parameters of concrete in tension at early-age by ring test

Monitor and Analyse on Temperature and Stress within Mass Concrete of Bridge Pier's Bearing Platform in Shanghai Changjiang Tunnel-Bridge Project