Abstract:The closure section of precast concrete segmental bridges (PCSBs) usually adopts the wet joint of cast‐in‐situ concrete, the width is generally 10–20 cm, and the regular longitudinal reinforcement is discontinuous, which makes the section the vulnerable part of the bridge. To explore the mechanical property of the wet joint in the closure section of PCSB under cyclic load, six wet joint specimens are tested to investigate the influence of loading mode, interface treatment mode, setting of regular reinforcement, and prestress level. The results show that the failure modes of wet joint specimens have similar characteristics, careful roughening of joint surfaces can improve the bonding effect of the new and old concrete and delay the cracking of the specimen, the cracking load of the specimen increases by 10.3% after careful roughening. When the prestress level increases from 6 to 8 MPa and 10 MPa, the stiffness of the specimens increases obviously, and the fracture development of the specimen in the loading process is improved. The cracking load increases by 21.9% and 32.8%, the shear strength increases by 9.9% and 6.6%, respectively, but the ultimate displacement decreases by 5.6% and 11.4%, respectively. Then, the finite element model of the wet joint was established and verified, the influence of shear key, concrete strength, and wet joint width are selected for parameter analysis. It is found that stress concentration is easy to occur after shear key is set, which has adverse effects on structural flexural resistance. The shear capacity of the model decreases by 22.4% and 21.5%, respectively after the setting of single and double‐shear keys, but the stiffness of the wet joint model before cracking is improved. Compared with C50 concrete model, the ultimate bearing capacity of C60 and C70 concrete models is increased by 11.5% and 24.8%, respectively. Wet joint width has little influence on the mechanical properties of wet joints in the closure section. The research results provide references for design and construction of PCSB wet joints in practical engineering.

Investigation and Control of Cracks in Wet Joint of Concrete Box Girders

Control Measures for Thermal Effects During Placement of Span-Scale Girder Segments on Continuous Steel Box Girder Bridges

Temperature Field and Stress Field of Prestressed Concrete Box-Girder Bridge

Finite element analysis of temperature effect and crack-control measures for ultra-long concrete structures

Control Joints in Cast In Situ Concrete Slabs and Its Application

Cracking Mechanism and Simplified Design Method for Bottom Flange in Prestressed Concrete Box Girder Bridge

Field Test and Analysis on Hydration Heat Temperature of Concrete Box Girder in Jiangshi Bridge

Cracking Behaviour of Cast in Situ Reinforced Concrete Slabs with Control Joints

Influencing Factors Analysis on Cracking of PC Continuous Box-Girder Bridges

Early Age Properties and Cracking Control of Concrete

Theoretical Analysis of Temperature and Shrinkage Stresses of Box-Girder Section

Cracking Control for Diaphragm of Long-Span Prestressed Concrete Box Girder Bridge at the Early Age

Time-dependent behavior of PC box girder bridges considering non-uniform shrinkage and creep

Spatial behavior and strengthening analysis of fabricated PC hollow slab beam bridge with hinge joints

Analysis and Countermeasure of Crack Prevention on Bottom Plate of Large Span PC Continuous Rigid Frame Bridge

Temperature Control and Crack Prevention Measures for Concrete Ship Locks Subjected to Prolonged Casting Interruptions

Hydration temperature measurement and analysis of cast-in-situ box girder segment on top of pier

Investigation of drying-induced non-uniform deformation, stress, and micro-crack propagation in concrete

Cracking Appraisal and Anti-Crack Measures Research of Cross Sea Bridge Concrete

Cracking simulation and analysis of the mortise-and-tenon wet joints in Precast reinforced concrete ribbed girder Bridges

Experimental and numerical research on the performance of cast‐in‐situ concrete wet joints in closure section in precast concrete segmental bridges under cyclic loading