Abstract:In recent decades, concrete-filled steel tube (CFST) arch bridges have been widely constructed in China. With the increasing span and arch rib diameter of CFST arch bridges, the hydration heat of pumped mass concrete in the CFST arch causes greater temperature changes during the period of construction, leading to potential thermal stress-induced cracking of mass concrete enclosed in the steel tube. In this paper, a finite element model was established to simulate the hydration Heat transfer process of large-meter CFST arch which was compared with the measured data from the literature. Subsequently, the variation of thermal stress during hardening process was revealed combining with numerical implementation and analytical study, and there is a reasonable agreement between the analytical solutions and those obtained by numerical implementation. In addition, the effect of concrete creep on the thermal stresses due to hydration heat was taking into account in the calculation based on the relaxation coefficient method. The results show that the nonlinear temperature field generated from the hydration heat determines the nonlinear variation of the thermal stress of CFST structure during hardening process. The thermal stress increases rapidly at the beginning of the concrete hydration, and there is a large stress gradient along the radial direction of the arch cross section; the stress slowly decreases after peak, and there is residual thermal tensile stress in the concrete after the heat release. Concrete creep significantly reduces the thermal stress of the concrete in the early age, but the effect on the thermal stress of the steel tube is negligible.

Stress analysis of concrete slab in high CFRD and measures for improving the stress state

Numerical Analysis of Ultimate Strength of Concrete Filled Steel Tubular Arch Bridges

Finite element analysis of temperature effect and crack-control measures for ultra-long concrete structures

Impact Behaviors of CFT and CFRP Confined CFT Stub Columns

The simulation of high compressive stress and extrusion phenomenon for concrete face slabs in CFRDs under strong seismic loads

THE ANALYSIS AND AMENDATORY MEASURES OF TEMPERATURE STRESS OF FACE SLAB OF A CONCRETE-FACED ROCKFILL DAM WITH EXTRUSION WALL

Numerical Analysis on Concrete-Filled Wide Rectangular Steel Tubular (CFWRST) Stub Columns under Axial Compression

Theoretical analysis on bond-slip constitutive relationship on tube and concrete interface in centrifuge concrete filled steel tubular structures

Numerical Simulation of Deformation and Strength of Reinforced Concrete Slabs under Thermal-Mechanical Loads

TEMPERATURE STRESS FINITE ELEMENT ANALYSIS AND STUDY ON STRAIN MONITORING AT MASS CONCRETE BASE SLAB WITH SLIDING LAYER

Simulation Analysis of Thermal Stress of CFST Arch Bridge During Exothermic Hydration Process

Comparative Study on Interface Elements, Thin-Layer Elements, and Contact Analysis Methods in the Analysis of High Concrete-Faced Rockfill Dams

Effect of built-in temperature difference on curling and stresses in cement concrete slabs

Stress Analysis of Concrete Materials Based on Finite Element Analysis

Effect of elevated temperature on thelow-velocity impact performances of reinforced concrete slabs

Research on Upper Slsb Stress Influence Lower Shear Degree in Double Concrete Slab Composite Beam

Time-dependent Deformation in High Concrete-Faced Rockfill Dam and Separation Between Concrete Face Slab and Cushion Layer

Three-dimensional refined analysis of seismic cracking and anti-seismic measures performance of concrete face slab in CFRDs

Theoretical and finite element analysis of engineered cementitious composite (ECC) link slab in hollow slab beam bridge base on different load conditions

Investigation on stress increments of unbounded pre-stressed strands of cast-in-situ concrete hollow floor slabs

Stress Distribution Analysis of Concrete in Deep Deck Flange of Composite Slim Beam