Abstract:The tensile strength of concrete material increases with the strain rate. The dynamic tensile strength of concrete material is usually obtained by conducting laboratory tests such as direct tensile test, spall test or splitting test (Brazilian test). It is commonly agreed now that the DIF obtained from dynamic impact test is affected by lateral inertia confinement. Therefore, those derived directly from testing data do not necessarily reflect the true dynamic material properties. The influence of the lateral inertia confinement, however, is not straightforward to be quantified in laboratory tests. Moreover, concrete is a heterogeneous material with different components, but is conventionally assumed to be homogeneous, i.e. cement mortar only, in most previous experimental or numerical studies. The aggregates in concrete material are usually neglected owing to testing limitation and numerical simplification. In the present study, a mesoscale concrete material model consisting of cement mortar, aggregates and interfacial transition zone (ITZ) is developed to simulate direct tensile tests and to study the influences of the lateral inertia confinement and heterogeneity on tensile strength of concrete material with respect to strain rates between 1/s and 150/s. The commercial software AUTODYN with user provided subroutines is used to perform the numerical simulations of SHPB tests. The model is verified by testing data obtained by others. Numerical simulation results indicate that the lateral inertia confinement contributes to the dynamic increase factor (DIF) of concrete material tensile strength. The lateral inertia confinement effect is specimen size and strain rate dependent. Based on the numerical results, discussions on the relative contributions from the lateral inertia confinement and the material strain rate effect on DIF of concrete material tensile strength are made. Empirical relations are proposed to remove the influence of the lateral inertia confinement in dynamic impact tests on dynamic concrete material strength. The effect of aggregates inside the concrete specimen on its dynamic strength is also investigated. The results demonstrate that it is very important to include aggregates in experimental and numerical studies of concrete material dynamic strength, otherwise significant inaccuracy might be induced.

Numerical Simulation and Assessment of Self-Induced Tensile Stresses in Steel Ring Restrained Concrete

Numerical Analysis of Ultimate Strength of Concrete Filled Steel Tubular Arch Bridges

Fine analysis of section stress of steel strand

STUDY OF BEARING CAPACITY AND COMPLETE STRESS-STAIN CURVES FOR CONCRETE FILLED SQUARE STEEL TUBE COLUMNS

PERFORMANCE RESEARCH ON LARGE CAST-STEEL NODE UNDER COMPLEX STRESS STATE

Analytical Model for the Bond Stress-Slip Relationship of Deformed Bars in Normal Strength Concrete

EXPERIMENTAL INVESTIGATION AND NONLINEAR FINITE ELEMENT ANALYSIS ON THE BEHAVIOR OF CONCRETE-FILLED SQUARE STEEL TUBULAR COLUMN CONNECTIONS

Theoretical analysis on bond-slip constitutive relationship on tube and concrete interface in centrifuge concrete filled steel tubular structures

Numerical Analysis for Crack Width of Reinforced Concrete Beam with Bond-Slip Effect

Mechanical properties and numerical simulation of crack interface in reinforced concrete

Simulating analysis of cantilever casting of prestressed concrete bridge

Numerical Simulation of Fracture and Damage Behaviour of Concrete at Different Ages

Numerical Analysis and Design of Concrete-Filled Wire Arc Additively Manufactured Steel Tube under Axial Compression

Lateral Stresses on Bond Strength of Deformed Steel Bars in Concrete: Analytical Model

STUDY ON NUMERICAL SIMULATION TECHNOLOGY OF STEEL REINFORCED CONCRETE STRUCTURES USING ANSYS

Study of Mechanics Behavior and Constitutive Model of Cemented Soil under Static Triaxial Tests

THE MECHANICAL PERFORMANCE OF SINGLE DIAGONAL LACING DOUBLE-WEB STAY MEMBERS OF OPEN CONCRETE FILLED STEEL TUBES WITH FOUR MAIN ELEMENTS

Numerical Analysis and Theoretical Study on the Interfacial Bonding Behavior of High-Strength Steel Stainless Wire Mesh-Reinforced ECC and Concrete

Mesoscale Modelling of Bond Performance Between Deformed Steel Bar and Concrete Subjected to Dynamic Loads

Analytical And Numerical Modeling Of Prestressed Continuous Steel-Concrete Composite Beams

Numerical analysis of concrete material properties at high strain rate under direct tension