Abstract:Alloys based on SnTe have been widely studied for their eco-friendly characteristics and good electrical performance in the high-temperature range above 600 K. In this study, SnTe-InTe solid solution alloy compositions of Sn 1 − x In x Te ( x = 0, 0.2, 0.4, 0.6, 0.8, and 1.0) were investigated for their phase formation behavior and thermoelectric properties. A single cubic SnTe phase was formed in x ≤ 0.4 samples, while x = 0.6 and 0.8 samples formed multi-phase with a tetragonal InTe phase. The carrier mobility gradually decreased with increasing x in the single cubic phase region ( x = 0-0.4), and a drastic reduction of 58% for x = 0.2 and 82% for x = 0.4, causing S and σ to decrease simultaneously compared to that of the pristine SnTe. Thus, the power factor gradually reduced to 0.06 mW/mK 2 for x = 0.4 compared to 1.57 mW/mK 2 for the pristine sample, as confirmed by the weighted mobility reduction behavior. The lattice thermal conductivity showed a gradual decrease in the simple cubic phase region, owing to the additional point defects formed by In substitution of Sn sites. Consequently, zT gradually decreased from 0.31 for the pristine to 0.02 for x = 0.4 sample due to the degradation of carrier transport properties, specifically Hall mobility, outweighing the total thermal conductivity reduction. The maximum zT value of 0.50 at 750 K was observed for InTe ( x = 1.0). Additional analysis using the single-parabolic-band model indicated that zT enhancement through carrier concentration optimization was not feasible for the alloy samples. Graphical

Synthesis and Transport Properties of In 4 (Se 1− x Te x ) 3

Synthesis And Transport Properties Of In-4(Se1-Xtex)(3)

Mid-temperature Thermoelectric Performance of Zone-Melted Sb2(Te,Se)3 Alloys Near Phase Transition Boundary

Electronic Transport and Thermoelectric Properties of Te-Doped Tetrahedrites Cu12Sb4-yTeyS13

Microstructure and Thermoelectric Properties of Bi0.5Na0.02Sb1.48-xInxTe3alloys Fabricated by Vacuum Melting and Hot Pressing

Phase Formation Behavior and Thermoelectric Transport Properties of Solid Solution Composition Between SnTe and InTe

Quaternary Thermoelectric Materials: Synthesis, Microstructure and Thermoelectric Properties of the (bi,sb)2(te,se)3 Alloys

Syntheses of a series of BaCu 2− x Ag x Se 2 ( x = 0 – 1.0) selenides and evaluation of their thermoelectric properties

Thermoelectric Properties of Quaternary Ag-Bi-Sb-Te Alloys

Thermoelectric Properties of S and Te-doped Cu2SnSe3 Prepared by Combustion Synthesis

Tuning of thermoelectric properties with changing Se content in Sb2Te3

Preparation and Investigation of Thermoelectric Properties of Cu3SbS4-Cu3SbSe4 Solid Solutions

Enhanced Thermoelectric Performance of Te-Doped Bi2Se3−xTex Bulks by Self-Propagating High-Temperature Synthesis

Fast synthesis and thermoelectric properties of BixCu2−3xSe0.95Te0.05 (x = 0, 0.001, 0.002, 0.003, 0.004)

In Situ Synthesis and Thermoelectric Properties of Te/FeTe2 Composites

Thermoelectric performance of Te composited with FeTe2 and co-doped with Sb and Se

Ultra-low lattice thermal conductivity and enhanced thermoelectric performance in Ag2−xSe1/3S1/3Te1/3 via anion permutation and cation modulation

High thermoelectric performance and low thermal conductivity in Cu2−yS1/3Se1/3Te1/3 liquid-like materials with nanoscale mosaic structures

High thermoelectric performance of Cu3SbSe4 nanocrystals with Cu2-xSe in situ inclusions synthesized by a microwave-assisted solvothermal method

Thermoelectric Properties of Low Te Concentration‐Doped Cu2ZnSnSe4‐Based Quaternary Alloys

Enhanced Thermoelectric Performance of Cu2Se Alloys by Simultaneous Engineering of Thermal and Electrical Transport Properties Through S and Te co‐doping