Abstract:As tellurides and selenides of Bismuth are extensively used thermoelectric materials in the low-temperature range with refrigeration application, A concerted effort is put forth to boost the ZT by co-doping the pristine Bi 2 Se 3 with antimony (Sb) on cation end and tellurium (Te) on anion side of the compound. The double sintered solid-state reaction method is employed in the preparation of Bi 2 Se 3 and (Bi 1− x Sb x ) 2 Se 2.7 Te 0.3 polycrystalline pellets, with x = 0.02, 0.04, and 0.06. The sample exhibits a rhombohedral structure with the space group of R m. FESEM and EDAX analysis are used to confirm surface morphology and elemental composition of the produced samples. The thermoelectric measurements for the pristine and co-doped samples were conducted by the physical property measurement system as well as a considerable increase in the Seebeck coefficient of − 115 μV/K is observed for 0.02 doping of the Sb which is 4.2 times greater than as for pristine (S = − 28 μV/K). Higher concentration doping ( x = 0.04, 0.06) has not reflected any Seebeck coefficient advancement. In contrast, the lowest total thermal conductivity at a low-temperature regime (< 50 K) is observed for x = 0.06 doping concentration which at near room temperature increases beyond the pristine thermal conductivity; whereas, x = 0.02, 0.04 doping concentration shows a decrement in total thermal conductivity at low, at room temperature region the values are almost equivalent to that of pristine. The co-doped samples' electrical resistivity is substantially less than pristine sample. The highest power factor of 3 × 10 –4 μW/mK 2 is obtained for the x = 0.02 sample. The highest ZT value for the x = 0.02 sample is almost 28 times more than a pristine sample. We conducted a study where we combined experimental and DFT methods to investigate thermoelectric properties incorporated into pristine and doped with antimony and tellurium on Bi 2 Se 3 . We have employed this combination to investigate the partial density of states, Seebeck coefficient, power factor using the Boltzmann transport equation. Theoretical thermoelectric data were derived and compared to experimental observations. Hence, using combined experimental and theoretical investigations helps to predict with higher accuracy of thermoelectric properties of semiconducting materials.

Syntheses of a series of BaCu 2− x Ag x Se 2 ( x = 0 – 1.0) selenides and evaluation of their thermoelectric properties

Tuning of thermoelectric properties with changing Se content in Sb2Te3

Mid-temperature Thermoelectric Performance of Zone-Melted Sb2(Te,Se)3 Alloys Near Phase Transition Boundary

Enhanced Thermoelectric Properties of Cu2SnSe3-Based Materials with Ag2Se Addition

Structural transformation and thermoelectric performance in Ag2Te1−Se solid solution

Enhanced Thermoelectric Performance of Cu2Se Alloys by Simultaneous Engineering of Thermal and Electrical Transport Properties Through S and Te co‐doping

Enhanced thermoelectric properties of Cu-Se system via bond-structure adjustment by Ag-doping

Thermoelectric properties of Gd and Se double substituted tetrahedrite

Fast synthesis and thermoelectric properties of BixCu2−3xSe0.95Te0.05 (x = 0, 0.001, 0.002, 0.003, 0.004)

Preparation and Investigation of Thermoelectric Properties of Cu3SbS4-Cu3SbSe4 Solid Solutions

Incommensurately Modulated Structure in AgCuSe‐Based Thermoelectric Materials for Intriguing Electrical, Thermal, and Mechanical Properties

Surface Chemistry and Band Engineering in AgSbSe 2 : Toward High Thermoelectric Performance

High Thermoelectric Performance of AgSb1-xPbxSe2 Prepared by Fast Non-Equilibrium Synthesis.

Ultralow Thermal Conductivity of Thermoelectric Compound Ag2BaGeSe4

A comprehensive experimental and DFT analysis on thermoelectric properties of Sb, Te co-doped Bi2Se3 polycrystals

High entropy effect on thermoelectric properties of the nonequilibrium cubic phase of AgBiSe2-2 xSxTex with x = 0-0.6

Stoichiometric manipulation to enhance the thermoelectric and mechanical performance of Ag2Se1+x

Enhancement of the Thermoelectric Performance of Cu 2 GeSe 3 via Isoelectronic (Ag, S)-co-substitution

Tuning Ag content to achieve high thermoelectric properties of Bi-doped p-type Cu3SbSe4-based materials

High Thermoelectric Performance of AgSb 1– x Pb x Se 2 Prepared by Fast Nonequilibrium Synthesis

Ultra-low lattice thermal conductivity and enhanced thermoelectric performance in Ag2−xSe1/3S1/3Te1/3 via anion permutation and cation modulation