Abstract:Silver bismuth diselenide (AgBiSe2) has attracted much attention as an efficient thermoelectric material owing to its low thermal conductivity. However, AgBiSe2 exhibits multiple crystal structural transitions with temperature, and high thermoelectric performance was realized only in the high-temperature cubic phase. We previously reported the stabilization of the cubic phase in AgBiSe2-2xSxTex with x = 0.6-0.8 at room temperature using a high-entropy-alloy (HEA) approach. In this paper, we succeeded in stabilizing the cubic phase in AgBiSe2-2xSxTex with x = 0-0.6 using an ice-quenching method and investigated the HE effect on thermoelectric properties below room temperature to avoid the emergence of a hexagonal phase above room temperature. Cubic AgBiSe2-2xSxTex exhibited n-type conductivity at 10-300 K. The increase in electrical conductivity is due to a combined effect of increased charge density and electron mobility, depending on the sample. It is evident that charge carrier density strongly increases in the x = 0.4 sample while the mobility remains roughly the same compared to the x = 0.0 sample. In x = 0.2 and 0.6 samples, electronic conductivity increases primarily due to enhanced mobility. S and Te substitutions induced a variation in the band structure, resulting in carrier mobility enhancement. Furthermore, thermal conductivity showed reduction tendency with increasing amounts of S and Te due to the enhancement of phonon scattering. Simultaneous electronic conductivity increase and thermal conductivity reduction resulted in the systematic improvement of ZT values for HE-type cubic AgBiSe2-2xSxTex.

Thermoelectric Properties of Quaternary Ag-Bi-Sb-Te Alloys

Mid-temperature Thermoelectric Performance of Zone-Melted Sb2(Te,Se)3 Alloys Near Phase Transition Boundary

Influence of Ag_2Te Doping on the Thermoelectric Properties of p-type Bi_(0.5)Sb_(1.5)Te_3 Bulk Alloys

Influence of Ag2te Doping on the Thermoelectric Properties of P-Type Bi0.5sb1.5te3 Bulk Alloys

Thermoelectric Properties of Ag Doped Pseudo-binary Alloys (PbTe)1-x(SnTe)x

Anisotropic thermoelectric transport properties of Bi0.5Sb1.5Te2.96+x zone melted ingots

Microstructure and Thermoelectric Properties of Cubic AgPb18Sb1−xTe20 (x = 0.1, 0.3, 0.5) Compounds

Enhanced Thermoelectric Properties Obtained by Compositional Optimization in P -Type Bi X Sb 2− X Te 3 Fabricated by Mechanical Alloying and Spark Plasma Sintering

Improved Thermoelectric Properties of BiSbTe-AgBiSe 2 Alloys by Suppressing Bipolar Excitation

Thermoelectric performance of (AgBiTe2)1-x(SnTe)x with stable cubic enabled by enhanced configurational entropy

Thermoelectric Properties of Non-Stoichiometric Agsbte2 Based Alloys with A Small Amount of Gete Addition

Thermoelectric Properties of Hydrothermal Synthesized Bi-Te-Se Alloys

Transport Properties of SnTe–Bi2Te3 Alloys

Thermoelectric Properties of the Cubic AgPb10SbTe12

Phase equilibria of Ag–Sb–Te thermoelectric materials

High entropy effect on thermoelectric properties of nonequilibrium cubic phase of AgBiSe2-2xSxTex with x = 0-0.6

Phase compositions, nanoscale microstructures and thermoelectric properties in Ag2-ySbyTe1+y alloys with precipitated Sb2Te3 plates

High entropy effect on thermoelectric properties of the nonequilibrium cubic phase of AgBiSe2-2 xSxTex with x = 0-0.6

Optimized Thermoelectric Properties of Bi0.48Sb1.52Te3 Through AgCuTe Doping for Low-Grade Heat Harvesting.

Doping Effect on Thermoelectric Properties of Nonstoichiometric AgSbTe 2 Compounds

Enhanced Thermoelectric and Mechanical Performances in Sintered Bi 0.48 Sb 1.52 Te 3 –AgSbSe 2 Composite