Abstract:This paper presents the design and test results for a dual-lane fault-tolerant PM motor for a safety critical aircraft actuator. Motor topology has been chosen to meet the system availability and reliability criterion considering principal faults that can occur within the motor including winding open circuit, line to line and phase to ground short circuits. The motor has two 3-phase windings which are powered from two independent inverters connected to different power supplies. The motor control strategy employs a healthy winding channel to have the capability to drive the load with the other winding channel short circuited in a faulted condition. The windings are designed to have a high impedance to limit the short circuit current to 1 p.u. A rectangular winding conductor is chosen to achieve a higher slot fill factor and for better manufacturability, which would also minimise the probability of turn to turn faults due to its thicker insulation. The effect of lateral magnetic pull has been considered to determine the locations of the dual-lane windings. Performance has been predicted by finite element analysis in healthy and faulted conditions. A prototype machine has been built and tested. Test results agree with the analysis in healthy and most of faulted conditions. However, measured drag torque with shorted windings is greater than the prediction at higher speeds, which is thought to be the effect of eddy currents in the conductors and magnets. It has confirmed that the induced current in a shorted turn is greatly affected by its location and the induced current may not be limited to 1 p.u. by short circuiting the machine phase terminals.

Design of fault tolerant permanent magnet motor in direct drive electromechanical actuator

Fault-Tolerant Operation for Single-Phase Open Circuit of Dual-Armature Flux-Switching Permanent Magnet Machine by Connecting Neutral Points

Fault-Tolerance Performance Analysis of a Five-Phase Permanent-Magnet Linear Synchronous Machine

A Novel Dual Permanent Magnet Fault-Tolerant Vernier Machine with Hybrid Stator Configuration

Modeling and Realization of Multiphase Permanent Magnet Synchronous Motor Variable Speed System

Design and Analysis of a Five-Phase Permanent-Magnet Synchronous Motor for Fault-Tolerant Drive

A 5-Phase Fault-Tolerant Brushless Permanent Magnet Motor Drive for an Aircraft Thin Wing Surface Actuator

Dynamic Modeling of Surface-Mounted Permanent Magnet Motors Considering Saturation

Optimization Of The Five Phase Fault Tolerant Motor Based On Ansoft Simulation

Remedial Operations for Open- and Short-Circuit Faults of Permanent Magnet Fault Tolerant Motor.

Operating Principle and Performance Analysis of a Novel Stator-PM Fault Tolerant Machine

Two Fault Tolerant Strategies for Four-Phase Permanent-Magnet Fault-Tolerant Machine

Remedy for open-circuit fault of 4-phase permanent magnet fault tolerant motor

Optimized Design of High Torque Density Permanent Magnet Synchronous Motor with Halbach Magnet

Control of Dual Three-Phase Permanent Magnet Synchronous Motor under Open Phase Fault Conditions

Design and Analysis of a Five-phase Flux-Intensifying Fault-Tolerant Permanent-Magnet Motor with Active Sensorless Strategy under Multimode Operation

Nonlinear Analytical Modelling for Surface-Mounted Permanent Magnet Motors with Magnet Defect Fault

Simple fault tolerant control of dual three-phase PMSM under one phase open-circuited condition

Twofold Fail-Work Remedy for Reconfigurable Driver and Windings of Four-Phase Permanent Magnet Fault-Tolerant Motor System

Modeling and Analysis of Assembly Faults of a Dual-Stator Low-Speed High-Torque Permanent Magnet Drive Machine

Design and test results for dual-lane fault-tolerant PM motor for safety critical aircraft actuator